1) conductivity
[英][,kɔndʌk'tiviti] [美][,kɑndʌk'tɪvətɪ]
导电率
1.
The development principle,composition design and fabrication technology of CuNi-Si alloy were discussed,correlations of the weight ratio of Ni and Si to the performance of the alloy,the type and amount of added alloy elements as well as fabrication technology were summarized,and the change rule of hardness and conductivity of the Cu-5.
2Si合金时效后硬度和导电率的变化规律。
2.
5 h,cold deformed with the degree of 25%～35%,then aged at(520±10) ℃ for 2 h,the hardness and electric conductivity of the Cu-Ni-Cr-Be-Ti alloy can achieve 256 HB and 47.
试验结果表明,该合金经(950±10)℃×1·5h固溶+25%～35%的冷变形+(520±10)℃×2h时效处理后,其硬度为256HB,导电率为47·23%IACS,室温下抗拉强度775MPa,屈服强度678MPa,伸长率20%,其物理性能和力学性能均能满足服役条件苛刻的汽轮发电机转子槽楔的使用要求,对于研究开发槽楔合金材料具有重要意义。
3.
03 and good conductivity of 48%IACS.
结果表明,CuNiCrSi合金最佳固溶处理工艺为 925℃×1 5h水冷, 40%预冷变形后再经 480℃×2h时效,其硬度可达到 249HV0 03,导电率为 48%IACS。
2) electrical conductivity
导电率
1.
The tensile strength reaches to about 421MPa, meanwhile, the electrical conductivity is about 73.
3Sn的合金线材,抗拉强度约为421MPa,导电率为73。
2.
The effects of solid solution and aging parameters on microstructure and electrical conductivity properties of Cu-0.
18Zr合金的显微组织和导电率的影响,在固溶温度920～1000℃和固溶时间0。
3.
The effects of solution-ageing on microstructure and properties of Cu-Ni-Al-Si alloy were analyzed with SEM,hardometer,eddy electrical conductivity tester and universal materials testing machine.
用扫描电镜、硬度计、涡流导电率测试仪和万能试验机测试分析了固溶-时效工艺对Cu-Ni-Al-Si合金组织和性能的影响,探讨了合金的强化机理。
3) electro-conductivity
导电性，电导率，导电率
4) specific conductivity
导电率，导电系数，电导率
5) apparent conductivity
视电导率
1.
Put forward is a new method of skin effect correction based on function relationship between the real part of apparent conductivity against frequency and true formation conductivity in uniform formation condition.
根据均匀地层感应测井视电导率实部与频率和地层电导率的函数关系提出了一种双频率校正与归一化校正相结合的趋肤效应校正新方法。
2.
A formula to estimate the apparent conductivity and sea ice thickness has been obtained after the correlation analysis of the EM apparent co.
通过电磁感应(EM)仪观测的视电导率与同点位钻孔测量数据对比分析,获得视电导率与海冰厚度的换算关系式,通过对用该关系式计算出的海冰厚度进行验证,表明电磁感应技术能够获得可靠的海冰厚度数据。
3.
The multiplying adding factor method must divide apparent conductivity into many segments and the function fitting method must select appropriate fitting function.
传统的感应测井趋肤效应校正方法包括乘加因子法和函数非线性拟合法,乘加因子法需要对视电导率曲线进行分段,函数非线性拟合法则要选取合适的拟合函数,这两种方法均含有人为因素,误差较大,不具备通用性。
6) electrical conductivity
电导率
1.
Study of microstructure,electrical conductivity and stress corrosion resistance of Al-Zn-Mg-Cu alloys;
Al-Zn-Mg-Cu合金组织和电导率及抗应力腐蚀性能研究
2.
Methods for measuring electrical conductivity of high temperature molten salts;
高温熔盐电导率测试方法
3.
Hardening characteristics and its electrical conductivity of 7055 aluminum alloy ageing;
7055铝合金的时效硬化特性与电导率
补充资料：半导体导电性(见半导体的导电与电荷输运)
半导体导电性(见半导体的导电与电荷输运)
electrical conductivity of semiconductor
半导体导电性eleetr、ea一conou以，v:‘，_‘ 一J一“。，瓜米早伙鼓幕由乌教着给话_
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条