1) saturation magnetization intensity
饱和磁性强度
2) saturation magnetization
饱和磁化[强度]，磁饱和
3) saturation magnetization
饱和磁化强度
1.
Size-dependent saturation magnetization and Curie temperature of nanocrystalline nickel
纳米金属Ni的饱和磁化强度和居里温度的尺寸依赖效应
2.
Single-phase ε-Fe3N magnetic fluid with saturation magnetization 1633Gs was successfully prepared by homemade equipment.
采用自行研制的氮化铁磁性液体热解装置,制备出最高饱和磁化强度Ms=0。
3.
The influences of deposition time on the covercivity and saturation magnetization of electroless CoWP thin films were studied, and the surface topography, elemental composition, micro-structure and magnetic properties of CoWP thin films were tested respectively by FSEM, XRD and VSM.
研究了施镀时间对化学镀CoWP薄膜矫顽力和饱和磁化强度的影响,并利用场发射扫描电子显微镜(FSEM)、X射线衍射(XRD)和振动样品磁强计(VSM)研究了CoWP磁性薄膜的表面形貌、成分、微结构及磁学性能。
4) specific saturation magnetization
比饱和磁化强度
1.
The results show that the increase of Ni content leads to the increase of amorphous forming ability,specific saturation magnetization changes complexity and reaches maximum at x=15,coercivity decreases all the while.
结果表明:随Ni含量的增加,FeNiZrNbB系合金的非晶形成能力增强,比饱和磁化强度变化相对复杂,当x=15时达到最大值,而矫顽力却一直呈下降趋势。
2.
Effects of the deposits thickness and heat treatment temperature on the coercive force and specific saturation magnetization were investigated.
通过化学镀方法获得纳米晶Co-B合金,分别研究了沉积层厚度和热处理温度对其矫顽力和比饱和磁化强度的影响。
3.
Their specific saturation magnetization σ s and specific surface area S a were measured.
通过测量它的比饱和磁化强度σs 与比表面积Sa,得出经验公式σs(Sa) =σs(∞ ) ( 1-aSa) ,运用非共线磁结构理论很好地解释了上述经验公式 ,并得到纳米晶的非共线表面层的厚度。
5) saturation magnetization
饱和磁感应强度
1.
To defermine the suitable sintering temperature of NiZn ferrite materials with different Zn contents,NiZn ferrite materials were prepared by oxide method and the effects of sintering temperature were investigated on the initial permeability,power loss,saturation magnetization and microstructure of the material.
为得到Zn含量不同时NiZn铁氧体材料的最佳烧结温度,用氧化物法制备了NiZn铁氧体材料,研究了烧结温度对材料起始磁导率、功耗、饱和磁感应强度和微结构的影响。
6) saturation magnetic induction
饱和磁感应强度
1.
The results show that the amorphous alloys exhibit the high saturation magnetic induction(B_s) when the ration of Fe and Co content is equal to 3～4 at a certain content of Si and B.
研究了FeCoSiB非晶合金中的Fe、Co元素之间的成分配比对非晶合金饱和磁感应强度的影响。
2.
In this paper,the present status of research on MnZn ferrites with high density,high permeability (μ)and high saturation magnetic induction(B_s)is summarized.
综述了高密度高磁导率高饱和磁感应强度MnZn铁氧体的研究现状,阐述了配方体系、预烧工艺、添加剂、成型和烧结工艺等因素对MnZn铁氧体的密度、磁导率和饱和磁感应强度的影响。
3.
For overcoming the blemish that the traditional blast method spends long time multivariate statistical analysis is applied to the measurement of saturation magnetic induction of soft magnetic materials.
饱和磁感应强度是磁性材料静态参数的一个重要指标。
补充资料：磁性油墨
分子式：
CAS号：
性质：选用可磁化的颜料，如氧化铁黑(Fe3O4)、氧化铁棕(Fe2O3)，这些粒子大多为小于lμm的针状结晶。经磁场处理极易做到带磁排列，获得较高的残留磁性，加入油墨中后制成的油墨显现磁性，成为磁性油墨。它在银行票证和邮政业务的分类、检索、辨认等方面应用颇广。可制成磁性铅印油墨、磁性胶印油墨等品种。
CAS号：
性质：选用可磁化的颜料，如氧化铁黑(Fe3O4)、氧化铁棕(Fe2O3)，这些粒子大多为小于lμm的针状结晶。经磁场处理极易做到带磁排列，获得较高的残留磁性，加入油墨中后制成的油墨显现磁性，成为磁性油墨。它在银行票证和邮政业务的分类、检索、辨认等方面应用颇广。可制成磁性铅印油墨、磁性胶印油墨等品种。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条