1) solidification temperature
凝固温度
1.
Solidification Temperature of Concasting Mold Fluxes;
连铸结晶器保护渣的凝固温度
2.
The results show that with increasing amounts of added TiO2, the viscosity and solidification temperature (θs) of the MF decrease gradually, and then increase rapidly.
研究表明:随着TiO2加入量的增加,MF的黏度和凝固温度(θs)先逐渐减小而后迅速增大。
3.
The results showed that the viscosity of mold fluxes could be decreased by TiO2,except that perovskite was precipitated that could increase viscosity and solidification temperature.
研究表明,TiO2可以降低连铸保护渣的粘度,但随着钙钛矿的析出,会增加凝固温度和粘度。
2) solidification temperature field
凝固温度场
1.
In this paper,a cooling water control problem in the process of continuous casting of steel is discussed; the boundary control problem of 2 dimensional solidification temperature field is modified into one consisting of the minimization of a linear form over a set of positive measures satisfying linear constraints.
对连铸过程的二冷水控制问题进行了讨论 ;将二维凝固温度场的边界控制问题 ,用线性化方法将原问题等价地转化为在几个Randon测度空间求最优测度的有限维线性优化问题 ,从而得到全局最优控制律 。
3) coagulation temperature
凝固浴温度
1.
Structure and property of Ionicell fiber dependent on coagulation temperature
凝固浴温度对Ionicell纤维结构及性能的影响
4) gradient freeze method
凝固温度梯度法
5) setting point
凝固温度(水泥等)，凝固点
6) initial solidification temperature
初始凝固温度
1.
The influence of initial solidification temperature on the microstructure at the brazed joint zone was investigated.
研究了钎焊温度对钎焊接头微观组织的影响 ,并利用图像软件Image ProPlus确定了不同初始凝固温度下α (Al)相在钎焊接头中的体积分数。
补充资料：铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条