1) amorphous ribbon
非晶带
1.
Surface corrugation law of amorphous ribbon,consisting of plane and groove was observed and analyzed,and its frequency order is 1×104/sSurface quality depends on the roughness of plane and groove and the difference between the two and ratio of width
观察分析了非晶带表面由平纹、沟纹组成的波纹规律，其频率数量级为１×１０４次／ｓ，平纹和沟纹本身的粗糙度、粗糙度的差值及二者宽度比决定着表面质量。
2.
7)Si_(12)B_(18)amorphous ribbons was carried out using rectangular pulse current.
7)Si_(12)B_(18)非晶带进行退火处理,研究了退火电流密度对非晶带巨磁阻抗效应的影响,同时研究了激励电流频率对退火处理后的非晶带巨磁阻抗效应的影响。
2) amorphous strips
非晶带
1.
The result show that the impedance of amorphous strips increase with frequency,and sensitively decrease with stress increase,especially in the frequency range from 1～100MHz.
结果表明,非晶带的阻抗随着频率的增加而增加,并随压力的增加变化更加敏感,尤其是频率在1~100MHz范围内时。
3) amorphous alloy ribbon
非晶成带
1.
Firstly,the principle of amorphous alloy ribbon is introduced,secondly analyse the main affecting factors of level control of amorphous alloy ribbon machine and put forward the level control algorithm,finally the experiment is performed for this control system and its result shows the control system performance satisfies the fact demand.
介绍了非晶成带的原理;分析非晶成带时影响液位的主要因素,并提出相应的液位控制算法;试验结果证明该控制算法适合本系统,成带质量好,满足实际生产的要求。
4) amorphous ribbon
非晶薄带
1.
Estimation of cooling rate of magnesium based amorphous ribbons prepared by melt spinning method;
估算单辊甩带法制备镁基非晶薄带的冷却速度
5) BNi_2 amorphous foil
BNi2非晶带
6) amorphous foils
非晶薄带
1.
Because of the high strength and temperature sensitivity of the metal glass,its lower limit is higher and upper limit is lower than that of crystal metal when bulk metal glass was prepared by amorphous foils explosive welding.
通过对非晶薄带涂铜以降低表面硬度,分析表明,其不仅能降低下限,同时使高速撞击产生的热量主要集中在涂层上,减小非晶薄带的受热影响区域。
2.
The explosive welding of preparing bulk metallic glass composites by amorphous foils is first to be discussed.
对非晶薄带爆炸焊接制备块体非晶复合进行讨论。
补充资料：非想非非想处天
1.佛教语。即三界中无色界第四天。此天没有欲望与物质﹐仅有微妙的思想。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条