1) expansion rate
膨胀率
1.
The influence of binders on the expansion rate of zinc gels in alkaline Zn/MnO_2 battery;
凝胶剂对碱锰电池锌膏膨胀率的影响
2.
Effects of salt crystallization of Na_2SO_4 and NaCl on concrete exposed to drying-wetting cycles were investigated by using index including concrete scaling amount,concrete expansion rate and strength loss rate,and chemical attack of concrete soaked in Na_2SO_4 and NaCl solutions was also measured.
以混凝土剥落量、膨胀率和强度损失率为评价指标,研究了干湿循环条件下Na2SO4和NaCl盐结晶对混凝土的破坏,并与在Na2SO4和NaCl盐溶液中浸泡的混凝土的化学侵蚀破坏结果进行对比。
3.
This article used concrete accelerating experiment to study the expansion rate and C-S-H gel generated in a different mix of materials.
采用混凝土加速实验,对添加不同混合材试样的膨胀率和试样中生成的C-S-H凝胶产物进行了研究,测定了不同混合材对试样膨胀率的影响以及所生成的C-S-H凝胶的化学组成,进一步验证C-S-H凝胶的Ca/S i比对碱骨料反应(AAR)的影响。
2) expansion ratio
膨胀率
1.
The expansion ratio,anti-inching ratio and gestation of tremella ice cream were proofed.
根据实验结果以综合性能比较,选出黄原胶和魔芋胶作为复合稳定剂的复配品种,以膨胀率、抗融化性、感官性能为产品的考核指标,对结果进行分析比较,最终确定复合稳定剂以及在银耳冰淇淋中的最佳用量和配比。
2.
There is an optimum expansion ratio while screw speed is 340 r/min.
结果表明,适当的螺杆组合,可以改善淀粉材料的挤出成型;随着螺杆转速的增加,样品膨胀率逐渐增大,在螺杆转速为340 r/min时膨胀率达到最大值;样品膨胀率亦随挤出温度的升高逐渐增大,在145℃膨胀率达到最大;含水量对淀粉材料的塑化程度和膨胀率影响显著。
3.
The effect of catalyst physical characteristics,dummy gas and liquid velocity and catalyst bed height on catalyst bed expansion ratio was researched.
在常温常压下用模拟渣油和模拟氢气近似模拟了微膨胀床渣油加氢处理反应器内的气液流动状态,考察了催化剂粒径和堆密度、虚拟气液流速以及催化剂装填高度对催化剂床层膨胀率的影响。
3) overrun
[英][,əʊvə'rʌn] [美]['ovɚ'rʌn]
膨胀率
1.
The conditions of aging and homogenizing affect the overrun and the melting-resistance of ice cream;
老化、均质条件对冰淇淋膨胀率和抗融性的影响
2.
Statistical models were developed to reveal the texture elements of ice cream which affect the overrun.
应用统计学模型研究了影响冰淇淋膨胀率的质构因素。
3.
Monostearin,sucrose fatty acid ester,hydrophilic monostearin,tripolyglycerol monostearates as the accuracy emulsifier in the ice cream product are compared with single factor and orthogonal, overrun and anti-meltdown are the estimate standards to value the finished product quality.
对冰淇淋生产中常用的四种乳化剂单硬脂酸甘油酯、蔗糖脂肪酸酯、亲水性单甘油酯和三聚甘油单硬脂酸酯,采用单因素和正交实验方法进行比较,以冰淇淋成品膨胀率和抗融性两个指标作为评价标准,评价各自最终产品品质。
4) rate of expansion
膨胀率
1.
Study on the rate of expansion and fracture in the lumber vertebral arch after the implantation of screw implanted;
螺钉植入后腰椎椎弓根骨折与膨胀率的观察
2.
The results shows that expansibility,rate of expansion and rate of free expansion of expansive soil changed from originally 111.
研究结果表明,改性处理后膨胀土的膨胀力、膨胀率和自由膨胀率分别由原来的111。
3.
This paper introduced the inspection and controlled method for mud removal time,cycle and route period of filtration pool,converse rinse time,converse rinse intensity and rate of expansion in water plant,as well as active role after these parameters being controlled.
介绍了水厂沉淀池排泥周期和排泥时间、滤池运行周期和反冲洗时间、滤池反冲洗强度和膨胀率的检测与控制方法 ,以及对这些参数控制后所产生的积极作用。
5) expanding rate
膨胀率
1.
Investigation on influencing factors of mud shale expanding rate in fresh water.;
影响泥页岩在清水中膨胀率因素的探讨
2.
Three methods for calculating pellets expanding rate were analyzed in order to evaluate the effect of calculation method on expanding rate.
为研究计算方法对直径法测量球团体膨胀率的影响,对3种计算方法进行了分析和比较。
3.
The result indicates: the proportion of the expansive agent and the proportion and the surface of the slag have a huge influence on the expanding rate of concrete, with the increase of the proportion of the expansive agent and the proportion and the.
结果表明 :膨胀剂的掺量和矿渣的细度、掺量对混凝土的膨胀率有较大影响 ,随着膨胀剂的掺量增加和矿渣细度、掺量的提高 ,混凝土的抗压强度提高 ,膨胀率增大 ,抗渗性能提高。
6) expansion factor
膨胀率，膨胀系数
补充资料：膨胀率
分子式：
分子量：
CAS号：
性质：材料在发泡前的密度除以发泡制品的表观密度所得的比值。用以表示发泡材料的膨胀程度。特别是在二次发泡中，可表示出预发泡珠粒在发泡成型时所得制品的体积膨胀倍数。
分子量：
CAS号：
性质：材料在发泡前的密度除以发泡制品的表观密度所得的比值。用以表示发泡材料的膨胀程度。特别是在二次发泡中，可表示出预发泡珠粒在发泡成型时所得制品的体积膨胀倍数。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条