1) terpene resin emulsion
萜烯树脂乳液
1.
A series of water-soluble paper/plastics laminating adhesives were prepared using an EVA emulsion, terpene resin emulsions and cationic styrene-acrylamide copolymer, and effects of surfactants in the terpene resin emulsions on properties of the adhesives were investigated.
用乙烯-醋酸乙烯共聚物(EVA)乳液、萜烯树脂乳液和阳离子型苯乙烯-丙烯酰胺共聚物研制了系列水基复膜胶,并考察了萜烯树脂乳液中乳化剂结构对复膜胶性能的影响。
2.
Aqueous polyurethane emulsion and terpene resin emulsion were prepared respectively by prepolymerzation and direct emulsification.
分别采用预聚法和直接乳化法制备了水性聚氨酯乳液和萜烯树脂乳液,讨论了萜烯树脂乳液的用量对聚氨酯乳液及胶膜性能的影响。
2) liquid terpine-resin
液态萜烯树脂
1.
A novel dispersed rosin size was prepared by emulsifying rosin, maleated rosin, liquid terpine-resin, which was used as flux, as well as small amount of paraffin wax with complex emulsifier SE-PE.
新型分散松香胶是以松香和马来松香为原料,采用SE-PE复合乳化剂,用液态萜烯树脂作助熔剂,并加入少量石蜡改性制备而成。
3) terpene resin
萜烯树脂
1.
When the content of terpene resin in SIS HMPSA reached to 50%,the properties were better.
用不同种类增粘树脂、不同牌号苯乙烯-异戊二烯嵌段聚合物(简称SIS)制备SIS热熔压敏胶,考察不同种类增粘树脂、不同牌号SIS及萜烯树脂含量对SIS热熔压敏胶性能的影响,结果表明:萜烯树脂是改性SIS热熔压敏胶适宜的增粘树脂,当萜烯树脂在SIS热熔压敏胶中含量达50%时,SIS热熔压敏胶性能较佳,随不同牌号SIS中两嵌段SI含量的增加,SIS热熔压敏胶的剥离强度有所增加,持粘力有所下降。
2.
Synthesis of terpene-catechol resin from terpene resin and catechol was reported in this paper.
以萜烯树脂和邻苯二酚为原料,合成了萜烯-邻苯二酚树脂。
3.
The terpene resin was subjected to hydrosilylation with trichlorosilane and dichloro-methylsilane to give a product with 42 6% silicone repeating units.
卢江等 [1]用硼氢化 -氧化反应对萜烯树脂环内双键进行羟基化 ,获得带羟基单元产物 ,然后与丙烯酰氯反应 ,得到带有丙烯酸酯的萜烯树脂 ,继而在引发剂引发下与甲基丙烯酸甲酯进行聚合 ,得到新聚合物 。
4) terpene resins
萜烯树脂
1.
Polymerization conditions of terpene resins from α pinene which is the major constituent of turpentine with catalyst of AlCl 3 is searched in this work .
本文介绍了在ＡｌＣｌ３的催化下以松节油合成萜烯树脂的实验过程及产品分析结果，探讨了催化剂的加入方式对产率的影
2.
This paper review the status of Terpene resins production and research its application in pressure sensitive adhesive.
本文对萜烯树脂生产和研究的基本情况及在压敏胶中的应用作了综述性报
5) acrylic resin emulsion
丙烯酸树脂乳液
1.
In order to collect the experimental data for industrial production,the study on preparation of acrylic resin emulsion for waterborne was carried out.
对水性油墨用丙烯酸树脂乳液的制备进行了研究,以便为工业化生产提供依据。
6) α-terpene resin
α-萜烯树脂
补充资料：萜烯树脂
萜烯树脂是由萜烯混合物聚合而成，结构式为分子式(C10H16)n,分子量650-1250，淡黄色粘稠液体或透明脆性固体。相对密度0．96-1．0，软化点80-130℃，玻璃化温度73-94℃。易溶于苯、甲苯、松节油、脂肪烃，不溶于水、甲醇、乙醇、丙酮、醋酸乙酯。稳定性好，遇光和热不变色。耐酸、耐碱。低温性、耐候性亦佳。可燃，无毒。
用作溶剂型压敏胶粘剂、纸塑复膜胶粘剂、SBS溶剂型胶粘剂、接枝氯丁胶粘剂、热熔胶等的增粘树脂。贮存于阴凉、通风、干燥的库房内．远离火种、热源。
用作溶剂型压敏胶粘剂、纸塑复膜胶粘剂、SBS溶剂型胶粘剂、接枝氯丁胶粘剂、热熔胶等的增粘树脂。贮存于阴凉、通风、干燥的库房内．远离火种、热源。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条