1) phase inversion
转相
1.
The results were as follows: Along with the increase of fat component in 5%～30% andlower press of homogenization in 10～30Mpa , the phase inversion happened more easily; the melting point of fat much affectedthe PIT (Phase Inversion Temperature) of emulsion;the viscosity increased smoothly then suddenly increased during phaseinversion;the aggregation of fat g.
研究了脂肪熔点、脂肪含量、均质压力对乳状液转相的影响,并用显微镜观察了转相过程。
2.
Phase inversion point of Liaohe oil field watery super heavy oil is about 18% of water content ratio.
以辽河油田含水超稠油室内试验为依据,讨论了含水原油的转相问题以及含水率、温度和剪切速率对含水原油流变性的影响。
3.
The selection and dosage of emulsifier,temperature of emulsification and phase inversion,auxiliary agents etc are tested.
对常压下制备分散型松香胶过程中的乳化剂选择、用量、乳化和转相温度、助剂等进行了试验，从而找出合适的乳化条件。
2) tri phase phase transfer catalyst (TPPTC)
三相相转移
1.
Polystyrene supported polyethylene glycol was synthesized and used as tri phase phase transfer catalyst (TPPTC) in the synthesis of p nitroanisole from p chloronitrobenzene.
合成制备了聚苯乙烯支载聚乙二醇 ,并以之作为三相相转移催化剂用于对硝基氯苯合成对硝基苯甲醚 ,考察了催化剂、NaOH、CH3OH等的用量对反应转化率的影响 ,得到了适宜的合成工艺条件为 :n(PCNB)∶n(CH3OH)∶n(NaOH)∶n(PTC) =1∶3∶3∶(0 0 3～ 0 0 5) ,反应温度约 78～ 80℃ ,反应时间 9～ 1 0h。
3) crystalline phase transformation
晶相转变
1.
The PVDF has the crystalline phase transformation in these methods.
利用固相法制备了掺杂有Nb2O5的PZT95/5压电陶瓷,采用固化、冷等静压、溶液混合法制备0-3型PZT/PVDF压电复合材料,经过对这几种方法的分析、比较后发现溶液混合法制备的样品中PZT微粉的分散性要优于前两种制备方法;这几种制备方法中PVDF均有晶相转变,但没有较为明显的β相PVDF存在,对复合材料的电性能的影响不大。
4) phase inversion
相转化
1.
Thermal stable poly(phthalazinone ether amide)(PPEA) ultrafiltration membrane was prepared through phase inversion method using N,N-dimethylacetamide(DMAc) as solvent.
以杂萘联苯聚芳醚酰胺(PPEA)为膜材料,N,N-二甲基乙酰胺(DMAc)为溶剂通过相转化法制备超滤膜。
2.
Polyethersulfone(PES) ultrafiltration membrane was successfully prepared by means of phase inversion method,with PES as raw material,Polyvinyl Pyrrolidone(PVP)as additive,and dimethylacetamide(DMAC) as solvent.
以聚醚砜(PES)为膜材,聚乙烯吡咯烷酮(PVP)为添加剂,N,N-二甲基乙酰胺(DMAC)为溶剂,用相转化法制备了超滤膜。
3.
Ethylene-vinyl alcohol copolymer MF membranes were prepared by the phase inversion technique.
以亲水性乙烯-乙烯醇共聚物为材料,采用相转化法,制备了亲水性的乙烯-乙烯醇共聚物微滤膜。
5) phase inversion emulsification
转相乳化
1.
The petroleum resin sizing agent was prepared with modified petroleum resin as raw material by phase inversion emulsification at ordinary pressure.
以改性的石油树脂为原料,采用常压转相乳化法制备了石油树脂施胶剂。
2.
After modification with maleic anhydride,the modified petroleum resin emulsion was synthesized with using C5,C9 petroleum resin as raw materials by ordinary pressure phase inversion emulsification.
以碳五(C5)、碳九(C9)石油树脂为原料,经马来酸酐加成改性后采用常压转相乳化法制备了改性石油树脂乳液。
6) phase inversion
相转变
1.
Application of the phase inversion of microemulsions in the organic contaminant separation;
微乳液相转变在分离有机污染物方面的应用
2.
Study on waterborne polyurethane-acrylate with multiple crosslinking modification and its phase inversion
水性聚氨酯丙烯酸酯的多重交联改性及其相转变
3.
Bulk polymerization of ABS resin Ⅰ.Study on phase inversion
本体法合成ABS树脂 Ⅰ.相转变过程的研究
补充资料：化妆品转相乳化
分子式：
CAS号：
性质： 指在乳化过程中由W/O乳液(或由O/W)转变成O/W乳液(或转变成W/O乳液)。促使转相乳化的发生，最重要的因素是温度和相比，一般用来制备O/W的化妆品。利用温度促使相变时，叫做转相温度乳化法。制造O/W乳液时，向油相中缓缓地添加水相。最初生成的W/O乳液，随水相增加转变成O/W型，经转相过程生成的乳液，其粒子细而均匀。
CAS号：
性质： 指在乳化过程中由W/O乳液(或由O/W)转变成O/W乳液(或转变成W/O乳液)。促使转相乳化的发生，最重要的因素是温度和相比，一般用来制备O/W的化妆品。利用温度促使相变时，叫做转相温度乳化法。制造O/W乳液时，向油相中缓缓地添加水相。最初生成的W/O乳液，随水相增加转变成O/W型，经转相过程生成的乳液，其粒子细而均匀。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条