1) interfacial shear viscosity
界面剪切黏度
1.
Effects of petroleum compound system on oil-water interfacial shear viscosity of crude oil treated with alkali
复合体系对与碱反应后原油油水界面剪切黏度的影响
2.
The interfacial film properties of resin and asphaltene separated from Saudi Arabia crude oil were investigated by interfacial shear viscosity,and explained by the molecular properties of the resin and asphaltene studied by IR,UV and VOP.
对含有胶质、沥青质的模拟油和模拟水体系,测定了其界面张力和界面剪切黏度。
3.
The molecular structures of asphaltenes and resins in Shengli crude oil were studied by IR,UV,and intensity of the interfacial film between oil and water was investigated by interfacial shear viscosity measurements,and the stability of emulsions was also researched.
采用红外和紫外光谱分析了胜利原油中胶质和沥青质的结构,采用界面剪切黏度对其油、水界面膜强度进行了表征,测定了胶质和沥青质模拟油油包水乳状液的稳定性。
2) shear viscosity
剪切黏度
1.
The proposed model indicates that the yield stress is one of the main causes for the shear-thinning effect and reveals why some materials possess double-Newtonian regions with the shear viscosity in the first region higher than that in the second region.
它揭示了某些材料存在的双牛顿区现象,并证明第一牛顿区的剪切黏度大于第二牛顿区的。
2.
A number of inventive methods have been developed for the measurement of interfacial shear viscosity.
综述测定界面剪切黏度的实验方法,重点介绍对其中几种常见实用的测定方法,包括这些测定方法各自的演变、测量原理、实验装置、灵敏度、优缺点等问题。
3.
The results showed that the apparent shear viscosity(ηa)and shear stress(τ)of all samples decreased with temperature increasing.
结果表明,随温度的升高,各试样的剪切黏度(ηa)和剪切应力(τ)下降;在250℃,剪切速率(γ)为200~10 000 s-1的条件下,各试样ηa和τ的差距逐渐缩小,流变曲线趋于重合。
3) interfacial shear strength
界面剪切强度
1.
The results showed that the interfacial shear strength between PBO fiber and epoxy resin were greatly improved after the modification,the.
通过单丝拔出实验研究了偶联剂对不同表面形态纤维的表面处理情况,结果表明:用偶联剂表面处理后,纤维与树脂间的界面剪切强度得到提高,偶联剂对未经烘干纤维表面处理比对烘干纤维处理的效果要好,与原丝相比,提高率可达69。
2.
A method of preparing single fiber pull-out specimens was designed,and the interfacial shear strength(IFSS) of Bf/epoxy resin composites was measured by single fiber pull-out rest.
设计了一种单根硼纤维拔出试样制备方法,并测试了不同树脂基体的硼纤维/环氧复合材料的界面剪切强度;研究了单根硼纤维拔出界面破坏过程。
3.
The single fiber fragmentation test has been used to determine the interfacial shear strength of composite materials.
单纤维段裂试验作为复合材料界面剪切强度的一种测试方法被沿用至今。
4) interfacial shear viscosity
界面剪切粘度
1.
Studies on interfacial shear viscosity and interfacacial tension of complx flooding systems;
复合驱油体系的界面剪切粘度与界面张力研究
2.
The interfacial tension,interfacial shear viscosity,and emulsion stability of diesel model oil/distilled water are measured respectively.
测定了柴油机油模拟油/蒸馏水体系的界面张力、界面剪切粘度和乳状液稳定性。
3.
The interfacial tension and interfacial shear viscosity of polymer solution/asphaltene model oil were measured respectively by Wilhelmy method and biconical bob method.
用挂片法和双锥摆法测定了聚合物溶液/沥青质模拟油体系的界面张力和界面剪切粘度,并对聚合物浓度对其的影响进行了分析。
5) IFSS
界面剪切强度
1.
Results showed that the interfacial shear strength (IFSS) values of the CF with modified sizing and unmodified sizing were in.
结果表明:炭纤维经改性乳液上浆剂和未改性乳液上浆剂上浆后,与未上浆相比,其单纤维复合材料的界面剪切强度(IFSS)分别提高了79%和41%,复合材料的层间剪切强度(ILSS)分别提高了14%和9%。
2.
The interfacial shear strength (IFSS) between fibers and resin was measured by the microbond test.
用Microbond测试方法表征了纤维与树脂基体的界面剪切强度,并用SEM观察微复合材料破坏形貌。
3.
Surface morphology,chemical composition,surface wettability,interfacial shear strengths(IFSS) to epoxy and fiber strength for PBO fibers were determined using scanning electron microscope(SEM),X-ray photoelectron spectroscopy(XPS),water contact angle measurements,micro-bond pull out tests and single fiber tensile tests,respectively.
通过SEM、XPS和静态接触角测试对处理前后纤维的表面形态、元素组成和表面浸润性能进行分析与表征,并采用Micro-bond测试方法测量纤维/环氧间界面剪切强度IFSS,利用单纤维拉伸测试评价等离子体处理对纤维力学性能的损伤。
6) interfacial shearing strength
界面强度剪切
补充资料:剪切黏度
分子式:
CAS号:
性质: 稳流状态下剪切应力与剪切速率之比。单位为帕(Pa)。剪切黏度是液体分子内摩擦的量度,也是物体黏流性质的一项具体反映。剪切黏度与拉伸黏度相比较常用,一般简称黏度时就是指剪切黏度。
CAS号:
性质: 稳流状态下剪切应力与剪切速率之比。单位为帕(Pa)。剪切黏度是液体分子内摩擦的量度,也是物体黏流性质的一项具体反映。剪切黏度与拉伸黏度相比较常用,一般简称黏度时就是指剪切黏度。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条