1) particle consistency
微粒浓度
1.
So many students are puzzled with the correct comparison between the relations of the particle consistency in electrolytic solution that correctly grasping it can help understand the knowledge of hydrolysis and electrolysis in order to improve students’ comprehensive analytic capability.
电解质溶液是中学化学的一个重要组成部分,是高考的热点,电解质溶液中微粒浓度关系的正确比较与判断,常常是很多学生学习的难点和盲点。
2) particulate loading(s)
微粒浓度;微粒量 PLS
3) concentration of solid panical
固体微粒浓度
4) Solid Concentration
颗粒浓度
1.
Distribution and Calculation of the Solid Concentration in Gas-Solid Risers;
气固提升管内颗粒浓度的分布与计算
2.
Numerical calculation of axial solid concentration profiles in a high efficiency regenerator;
高效再生器内轴向颗粒浓度分布的数值计算
3.
The solid concentration of gas-solid two-phase flow in a fluid catalytic cracking riser (φ186 mm×12 m) is measured with γ-ray attenuation technology.
在实验室流化床装置上用γ射线衰减技术对φ186mm×12m提升管内的FCC催化剂颗粒浓度进行了测量。
5) particle concentration
颗粒浓度
1.
Numerical simulation on particle concentration distribution in cyclone separator;
旋风分离器内颗粒浓度场的数值模拟
2.
Effects of particle concentration and optical thickness on flame temperature field reconstruction;
颗粒浓度和光学厚度对火焰温度场重建的影响
3.
The radial profile of particle concentration under different apparent gas velocities with different internals were measured along the dire.
分别从方截面正向、斜向上的颗粒浓度分布,讨论了内构件对颗粒轴向返混、径向掺混及截面浓度的作用,分析了构件尺寸对实验结果的影响。
6) solids holdup
颗粒浓度
1.
To investigate the pressure drop due to the friction between gas-solid suspension and CFB riser wall and its effect on the measurement of average solids holdups by pressure transducers,models for predicting the pressure drop and the solids holdup were developed.
为确定气固提升管充分发展段的摩擦压降及其对颗粒浓度测试的影响,提出了充分发展段内气固两相流与管壁间摩擦压力降的计算模型,由此获得充分发展段内真实颗粒浓度的计算公式;同时在两套提升管实验装置上对压力梯度分布和局部颗粒浓度进行了系统测试和对比分析。
2.
The pressure gradients of air-sand two-phase flow in a CFB riser were systematically measured in a 10m high CFB riser to investigate the axial distributions of averaged solids holdups of coarse particles and the effects of operation conditions.
在10m高提升管中对空气-沙子体系的压力梯度进行系统测试,研究了粗重颗粒平均颗粒浓度sε的轴向分布及操作条件对它的影响。
3.
A nonlinear model for generation of solids holdup time series in the CFB riser based on combination of chaos with artificial neural network was proposed.
基于气固循环流化床是一混沌动力学系统,故采用了耦合混沌理论中的重构相空间方法与人工神经网络的非线性映射功能,建立起提取气固循环流化床颗粒浓度时间序列的非线性模型,并将此模型应用到f100mm×16m,FCC固体颗粒的上行气固循环流化床系统。
补充资料：MH微粒硬质造牙材料
分子式：
CAS号：
性质：以甲基丙烯酸甲酯-苯乙烯共聚物为基质，以微粒二氧化硅(1000目以上)作填料，用有机硅烷处理后配制而成。它既能保持陶瓷牙的优点，又兼有塑料牙的长处，其力学性能又接近天然牙，是硬质复合的新型造牙材料。
CAS号：
性质：以甲基丙烯酸甲酯-苯乙烯共聚物为基质，以微粒二氧化硅(1000目以上)作填料，用有机硅烷处理后配制而成。它既能保持陶瓷牙的优点，又兼有塑料牙的长处，其力学性能又接近天然牙，是硬质复合的新型造牙材料。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条