1) Dehydration rate
脱水率
1.
The effects of the power of microwave,time of radiation,the weight and the thickness of material on dehydration rate of aluminium fluoride were discussed.
介绍了微波干燥的原理和主要特点,研究了利用微波辐射干燥氟化铝工艺,探讨了微波功率、微波辐射时间、物料质量、物料厚度对氟化铝脱水率的影响。
2.
48m~3/h ,the highest dehydration rate can be as high as 90.
48 m3/h时,脱水率可达90。
3.
With our treatment, the mechanical dehydration rate of the waste drugs after our treatment can exceed 64%.
处理后机械脱水率提高到 64%以上。
2) dewatering rate
脱水率
1.
The authors study the drying process of edible salt with microwave oven and analyze the impact of microwave power,radiation time as well as quality and thickness of materials on the dewatering rate of edible salt.
研究了利用微波干燥食盐的工艺,并分析了微波功率、辐射时间、物料质量和物料厚度对食盐脱水率的影响。
2.
The dewatering rate is related to sludge kinds, coagulant concentration is 0.
脱水率与污泥种类、絮凝剂种类、投加量、浓度、环境温度有关。
3) dewatering ratio
脱水率
1.
In order to promote the crude oil demulsification and improve dewatering ratio, we have synthesized a kind of cationic surfactant C in the lab.
为促进原油破乳,提高脱水率,在室内合成了一种阳离子表面活性剂组分C,并分析了合成过程中的影响因素。
2.
Using the crude oil of different water content ratio, the dewatering time is between 30min and 60min and the dewatering ratio is above 97%.
针对大庆油田高含水原油,将破乳剂GP与组分C复配,实施结果表明:复配后破乳剂的脱水速率比单一使用破乳剂GP或组分C有很大的提高,对于不同含水率的原油,在最佳复配比例下,脱水时间为30～60min时,脱水率大于97％,原油含水率越高,脱水速度越快,脱水率越高;使用复配破乳剂后,破乳温度从55℃降为40℃,节约了运行成本;外输原油平均含水在0。
4) dehydration efficiency
脱水效率
1.
Far-Infrared, microwave, and combination of microwave and other drying equipments were applied as heating source media in the natural rubber drying process, and the effect of drying technique and technical conditions on the dehydration efficiency, yield, quality, and operating costs were fully investigated.
采用远红外、微波和微波干燥组合作为橡胶干燥介质热源,对干燥胶料的脱水效率、产量、外观质量、产品质量、生产成本、工艺条件等进行研究。
5) Dehydration rate
脱水速率
1.
Dehydration rate was at lower level during the beginning 18 hours, then it increased gradually to the first peak at the 42nd hour, and reached the second peak at the 60th hour wh.
烤烟调制过程中烟叶脱水速率变黄前期小 ;之后逐渐增强直至定色中期 ,这是第一次由弱变强的脱水过程 ,主要表现为叶肉细胞脱水 ;定色后期出现第二次强度较大的脱水过程 ,表现为维管束脱
2.
This article described the test of fresh cucumber′s dehydration rate and the method to fresh-protecting store and transportation under natural condition.
试验表明,鲜黄瓜在自然条件下的脱水速率由快变慢;从存放的第二天开始脱水速率与黄瓜直径和质量显著负相关,而第一天的相关性不明显。
3.
The main factors influencing the viability, such as dehydration rate, water content and thawing temperature were studied.
在超低温保存中将丝状体包埋在含3%褐藻酸钙的胶球中,经硅胶砐湿法脱水后,探讨了脱水速率、胶球含水量及化冻温度对冰冻保存存活率的影响。
6) dry-down rate
脱水速率
1.
Correlation analysis on dry-down rate and quality traits in corn after physiological maturity;
玉米生理成熟后籽粒脱水速率与品质性状的相关分析
2.
The main results were as follows: it showed that grain filling rate,dry-down rate had high correlation with main agronomy traits.
试验选用9份自交系,按格列芬双列杂交方法Ⅱ设计,对玉米灌浆速率、脱水速率及其主要性状进行相关和通径分析。
补充资料：电导率(见电阻率)
电导率(见电阻率)
conductivity
d!日nd日O}已电导率(eonduetivity)见电阻率。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条