1) initial secant modulus (ISM)
初始割线模量
2) initial tangent modulus
初始切线模量
3) initial modulus
初始模量
1.
The impact of temperature and duration of heat treatment on the breaking strength,elongation at break,initial modulus and work to break of the fibers was investigated.
对玉米纤维进行不同方式的热处理实验,得出了热处理温度和热处理时间对断裂强度、断裂伸长、初始模量、断裂功的影响规律。
2.
The tensile strength and initial modulus were remarkably decreased and the breaking elongation and flexibility of grafted fiber were increased.
接枝后纤维强度和初始模量下降,断裂伸长和柔顺性提高;耐酸、耐碱能力随接枝率的增加而提高,热稳定性提高,回潮率下降。
3.
Results show that,crystalline,crystallite size, breaking strength and initial modulus of the fiber are all decreased after graft copolymerizations of MA.
分析讨论了纤维接枝后结晶度的变化情况,及结晶度与力学性能的关系,结果表明接枝MA后纤维的结晶度、晶粒度、断裂强度和初始模量均有下降。
4) the initial tangent elastic modulus
初始切线弹性模量
5) secant modulus
割线模量
1.
An undisturbed-soil secant modulus method for calculation of nonlinear settlement of soil foundations;
地基非线性沉降计算的原状土割线模量法
2.
According to experimental results of stress-strain relationships,the secant modulus and mobilized internal friction angle are analyzed,and the results show that the modulus and mobilized friction angle.
根据应力应变关系的试验结果,分析了膨胀性泥岩的割线模量和发挥内摩擦角,结果表明割线模量和发挥内摩擦角均随围压的变化而变化,且拟合了割线模量和发挥内摩擦角与应变的关系。
3.
The following paper analyzes nowadays calculating method of final ground settlement,tests and verifies the feasibility of calculating final settlement by secant modulus method,poses a suggestion of adopting secant modulus method to estimate final settlement.
对目前采用的最终沉降量计算方法进行了分析比较,通过工程实例,验证了割线模量法计算最终沉降量的可行性,提出了宜采用割线模量法估计最终沉降量的建议。
6) secant moduli
割线模量
1.
The secant moduli yield surfaces and the average stress concentration factors of the matrix are derived.
对于两种复合材料,即单向排列纤维形成的正交各向异性材料和在截面内随机排列纤维形成的横观各向同性材料,作出了割线模量,基体应力增大系数及屈服条件曲线。
补充资料：割线
通过圆周或其他曲线上任意两点的直线。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条