说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 过喷
1)  over peening
过喷
1.
The over peening effect is produced when the shot peening intensity is high,and it leads to the decrease of the fatigue life.
喷丸强度高时将产生过喷效应,导致疲劳寿命的降低,实验测得最佳喷丸强化弧高值为0。
2)  overspray ['əuvəsprei]
过量喷涂
1.
In industrial painting lines,approximately 25% ~ 60% of the paint is wasted as overspray,and the overspray paint is collected and treated in water-based solutions using traditional chemical paint detackification systems in large operation line such as automobile industry.
在工业喷漆生产线,大约有25%~60%的涂漆由于超过量喷涂而损耗。
3)  Sprayed Powder
过喷粉末
1.
Morphology and Microstructure of Sprayed Powder by Spray Forming;
喷射成形过喷粉末形貌及组织研究
2.
Contrast between GCr15 steel sprayed blank and sprayed powder
喷射成形沉积坯与过喷粉末的比较分析
3.
The products were investigated by means of OM and SEM,which shows that most of the sprayed powders display regular roundness though some of them aquire special forms.
应用喷射成形技术制备了GCr15钢沉积坯,同时收集了过喷粉末。
4)  spray transfer
喷射过渡
1.
Applied the longitudinal magnetic field to the process of spray transfer,the movement character of arc and liquid metal jet is obtained by high speed camera.
将该纵向磁场应用于喷射过渡MAG焊,利用高速摄像手段分析了电弧和液流束的运动特征。
5)  injection process
喷射过程
1.
Experiment and simulation of fuel injection process for dimethyl ether engine;
二甲醚发动机燃料喷射过程的试验与仿真
2.
The line pressure at injector side and nozzle needle lift were measured to evaluate the injection process of different mixing ratios of a bio-diesel.
通过测试不同工况下的高压油管嘴端压力和喷油器针阀升程,研究了不同配比生物柴油对柴油机喷射过程的影响。
6)  Injection Process
喷油过程
补充资料:过喷玉泉
【诗文】:
平生半为山淹留,马上欲去还回头。
两京尘路一双鬓,不见玉泉千万秋。





【注释】:



【出处】:
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条