说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 化学破乳
1)  chemical demulsification
化学破乳
1.
The chemical demulsification of crude oil emulsions(W/O emulsions) is reviewed in two parts on the basis of 55 papers published at home and abroad since 1990.
基于1990年以来国内外发表的55篇论文,对原油乳状液的化学破乳问题进行了综述。
2)  chemical emulsion breaking
化学破乳
1.
In order to remove phenol from coking wastewater,this article discusses the main technical points of removing phenol by liquid membrane,including the process of chemical emulsion breaking,and operation conditions of batch tower.
为脱除焦化废水中的酚,本文研究了新型化学破乳法液膜脱酚的工艺,确定了搅拌塔操作条件,并实际应用于焦化厂含酚废水的处理中,结果表明该工艺具有良好的脱酚效果。
2.
It has advantages over the chemical emulsion breaking method and the organic film disposal method in less engineering investment,low running cost and stable quality of water tr.
无机陶瓷超滤膜技术已用于处理攀钢冷轧厂乳化液废水,具有处理出水水质稳定,废油含水率低回收价值高,对环境不产生二次污染,与化学破乳法和有机膜处理法比较具有工程投资少、运行费用低、出水水质稳定等优点。
3)  chemical demulsifier
化学破乳剂
1.
A kind of high efficiency,low-selectivity and chea p compound biodemulsifier is prepared by chemical demulsifier and biodemulsifier.
为解决破乳剂的选择性强、破乳效率低的问题,采用化学破乳剂和微生物破乳剂复合的方法,研制出了广谱、高效、低成本的破乳剂,并用大庆三次采油采出液、塔河原油、南阳原油、蓬莱原油、俄罗斯混合原油进行了脱水、脱盐评价。
2.
The feasibility of demulsifying oil emulsions with a combined method of ultrasonic irradiation method and chemical demulsifier was analyzed theoretically and testified experimentally.
实验结果显示 ,化学破乳剂和超声波联合作用可以进一步提高原油的破乳脱水效率。
3.
The details of the novel nonchemical demulsifier,emulsion breaking methods and the technology have been mentioned as well.
本文主要对国内外化学破乳剂研究的新方向作了较全面的概括 ,同时对新型的非化学破乳剂、破乳方法及相关的破乳技术作了详细的论
4)  chemical demulsification method
化学破乳法
1.
4 and the concent of wire drawing oil is 4%) as research object,used chemical demulsification method and through laboratory experiment,adopted electrolyte and coagulant separately to deal with the wastewater.
4,拉丝油含量4%),选用化学破乳法,通过实验室实验,分别采用电解质和混凝剂处理废液。
5)  thermo-chemical demulsification
热化学破乳
6)  non-chemical demulsifier
非化学破乳剂
补充资料:破乳
破乳
demulsification

   将乳状液破坏以达到两相分离的过程。例如原油脱水、从污水中除去油珠、从牛奶中提取奶油等。
   根据分散相和连续相的性质  ,可采用不同的方法实现破乳。离心破乳即是用离心方法将两相分离;若乳化剂是离子型表面活性剂,则可在高压电场中使带电液珠移向一侧,称为静电破乳;利用超声波加速液珠间的聚集,也是一种破乳手段。但在工业上更普遍的破乳方法是加入一种叫做破乳剂的物质,以破坏吸附在油-水界面上的乳化剂,使其失去乳化能力。常用的破乳剂多是表面活性剂,它有很高的表面活性,能将界面上原来的乳化剂赶走以取而代之;同时它的分子具有分支结构,不能在界面上紧密排列成坚固的吸附膜,从而使乳状液的稳定性大大降低。例如由环氧乙烷与环氧丙烷共聚而成的聚醚表面活性剂,就是一种常用的原油破乳剂。对于以固体粉末作乳化剂的乳状液,若加入润湿剂(也是某种表面活性剂),使粉末粒子被一相完全润湿,从而脱离界面而进入该相之中,使乳状液破坏。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条