说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 线性热膨胀系数
1)  coefficient of linear thermal expansion
线性热膨胀系数
1.
The test method of the coefficient of linear thermal expansion of hardened cement paste and the effect of temperature,moisture content and curing age on the coefficient of linear thermal expansion of hardened cement paste were investigated,which would provide basis for the structure design of large-scale concrete.
研究了水泥石线性热膨胀系数的测试方法及温度、湿含量和龄期对其的影响,并进行了一定的理论分析,以期为长形混凝土结构设计提供一定的依据。
2)  linear thermal expansion coefficient
线热膨胀系数
1.
Based on theoretical and experimental study, the linear thermal expansion coefficient prediction theory was established on short fiber thermoplastic composite and the short fiber orientation and distribution was taken into consideration.
对SF -TPU(短纤维 -热塑性聚氨酯 )复合材料线热膨胀性能进行了理论与实验研究 ,考虑了短纤维取向分布的影响 ,建立了SF -TPU复合材料线热膨胀系数理论预测方程 ,理论预测与实验结果吻合较好。
3)  coefficient of linear expansion
热/线膨胀系数
4)  coefficient of linear expansion
线性膨胀系数,线膨胀系数,线胀系数
5)  linear expansivity
线性膨胀系数,线性胀率
6)  Linear expansion coefficient
线性膨胀系数
1.
Based on the operation of VRLA batteries a series of experiments on linear expansion coefficient,charge under high temperature and high pressure and high-low temperature cycle were done to verify the sealed effect of terminals sealed with the glue,and solving the problem of the terminal leakage.
通过对端子密封胶的线性膨胀系数、高温高压充电性能、高低温循环性能的测试,更好地验证了端子密封胶的性能,从而使铅酸蓄电池端子漏液问题得到解决。
补充资料:焦炭热膨胀系数


焦炭热膨胀系数
thermal expasion coeifficient of coke

jiaotan repengZhang xishu焦炭热膨胀系数(therma一。xpansion coeiffi-cient of coke)棒状演炭试样在受热过程中,温度每升高IK的伸长量与试样原长的比值。焦炭热膨胀系数a一告(瓮),K一。式中:为试样原长,m;dt为温度增加量,K;dL为试样伸长量,m。在20一l000C范围内焦炭随温度的升高而膨胀,加热温度超过炼焦终温时,焦炭将呈现出某些收缩(见焦炭收缩率)。焦炭的热膨胀系数,与生产焦炭的原料煤种类和加热速度有关。苏联穆契尼柯(皿.A.My~)曾于20世纪70年代用一般的热膨胀仪,以由不同煤化度煤炼得的焦炭,制成直径10~14~、长35~60~的焦样,分别以10℃/~升温速度加热到1000℃,并测量它们的热膨胀系数。结果表明,焦炭在加热到800一900’C时,热膨胀系数达到最大值,随后较快下降。不同煤化度煤炼制的焦炭,其热膨胀系数的差异还与焦样在炭化室内经历的热流方向有关。(见表)当加热速度较慢时,测得的平均膨胀系数略低些,但基本规律与表中所列数据一致。在较慢加热速度(2 .5~3℃/而n)下加热由单种煤炼得的焦炭试样时,焦炭试样中未产生新的裂纹。当焦炭试样是取自由配入不粘结添加物的配合煤炼得的焦炭时,由于焦炭结构不均一,受热时产生新的裂纹。在快速加热(热冲击)条件下,各种焦炭试样均会产生新的裂纹。因此,焦炭加热时所产生的破坏,主要取决于焦炭本身结构的不均一性和加热速度。焦炭平均热膨胀系数(x 10一‘)(K一’)二耳一一 (江中砒)
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条