1) surface pressure deform
表面压溃
2) superficial ulcer
表面溃疡
3) collapse
[英][kə'læps] [美][kə'læps]
压溃
1.
Accurate Simulation on Collapse History of Thin-walled Beam with Closed-hat Section;
闭口帽型薄壁梁压溃历程的精确仿真
2.
The destroyed process of this rigid resistance structure is from buckling to collapse.
这种刚性抗力件的破坏过程包括从屈曲破坏到压溃的过程。
3.
Considering the requirements of riser strength,system collapse,propagated buckling and limitation of floating,the smallest thickness that meets the requirements is determined.
综合考虑规范对立管强度的要求,防止发生压溃和屈曲扩展的要求及限制立管发生漂浮的要求三个条件,确定了满足条件的最小壁厚。
4) surface pressure
表面压力
1.
Comparison of surface pressure characteristics of bulbous bows in different profiles through wind tunnel tests;
不同型线结构船艏表面压力特性对比实验研究
2.
Changes of surface pressure with adsorption time were determined at different protein concentration and pH.
采用轴对称滴形分析法研究了大豆11S球蛋白在空气-水界面上的吸附动力学,主要检测了不同浓度和pH值条件下表面压力随吸附时间的变化。
3.
A figure for the surface pressure distribution at 0-deg yaw angle is also given.
通过对典型客车模型风洞试验过程、方法以及试验数据的分析介绍,给出了客车模型在60m/s风速时,气动阻力系数随横摆角的变化关系曲线,零横摆角时的表面压力分布。
5) surface pressure
表面压
1.
The results show that HBP-CMCHS can adsorb to the surface to decrease the surface tension of the solution, and the surface pressure of the adso.
采用红外、核磁共振和X射线衍射技术对产物进行了结构表征,并通过表面张力和表面压的测定研究了其表面性质。
2.
The polyacrylamide has little effect on the surfactant mono-layer at high surface pressure, but has considerable effect at low surface pressure.
在高表面压下 ,聚丙烯酰胺对表面活性剂单分子膜影响极小 ,在低表面压下影响显著。
3.
The surface pressures of six polyoxyethylene n - alkanol - water systems, polyoxyethylene n - octylphenol - water system and sodium dodecyl sulphate - water system are accurately correlated .
运用提出的状态方程,分别对6种烷基聚氧乙烯醚、辛基酚聚氧乙烯醚、十二烷基硫酸钠等表面活性剂水溶液的表面压数据进行了关联,并利用关联所得的参数预测了其他种类的烷基聚氧乙烯醚及辛基酚聚氧乙烯醚和十二烷基硫酸钠水溶液在不同温度下的表面压。
6) Press Pit on the Surface
表面压坑
补充资料：淬溃
1.水奔流貌。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条