1) mode bevel
出模斜度
2) taper angle
拔模斜度
1.
Based on the encapsulate curve of structural unit for the molded paper pulp,rela-tionship of the taper angle of structural unit was revealed for the molded paper-pulp and cushion perform-ance,and it was found that the best taper angle of structural unit is 4°~8°.
利用有限元分析软件,针对纸浆模塑典型结构单元,应用双线性运动增强型材料模型,进行系统力学分析,以力学分析得到的纸浆模塑缓冲结构单元的静态压缩曲线为基础,得出了缓冲包装结构拔模斜度对缓冲性能存在较大的影响,斜度在4°~8°时缓冲性能最佳的结论。
3) Draught,draft draw leave taper,draft angle
模锻斜度
4) leave
[英][li:v] [美][liv]
锻模斜度
5) draft angle
脱模斜度
1.
In this paper,the impact of draft angle to the moulding dimensions and the comprehension of the dimensions in plastic production with the unlabeled tolerance were discussed.
本文通过论述模具脱模斜度对模具尺寸的影响、塑料件未注公差的确定,并通过一个设计实例进行了说明。
6) draft angle
模锻斜度(拔模斜度)
补充资料：斜度标
1.铁路或公路旁的路线倾斜标志。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条