说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 粘接漏钢
1)  sticking break-out
粘接漏钢
2)  sticker breakout
粘接性漏钢
3)  breakout by sticking
粘结漏钢
1.
4 slab caster of JISCO,the reasons of breakout by sticking of 50# steel slab were analyzed systematically.
本文结合酒泉钢铁公司4#板坯生产实际,系统分析了50#钢粘结漏钢的原因,从保护渣、结晶器、冷却水以及工艺操作等方面有针对性地制定了措施,杜绝了粘结漏钢事故,稳定了生产。
2.
Analysis consider that the reason of breakout by sticking is bad capability of the powder,such as lower depth of liquid powder,less consumption and low proportion of glass phase in the powder.
分析认为,济钢大板坯连铸机出现粘结漏钢的原因是保护渣的性能不良,其中液渣层厚度、渣耗量及玻璃相比例偏低,以及结晶器液面波动,拉速提升过快等。
3.
It is shown that the breakout by sticking is caused by low temperature of molten steel and high withdrawal speed and illogicality capability of protecting slags.
通过统计分析板坯连铸生产中出现的漏钢事故,认为钢水温度低、拉速快和保护渣理化性能不合理易导致粘结漏钢;对弧不良、钢水温度高、拉速快是造成裂纹漏钢的主要原因;开浇和接头漏钢主要是中间包上水口和塞棒烘烤效果不好及出苗时间不足造成的。
4)  sticking breakout
粘结漏钢
1.
Optimization for flux of high-carbon steel #45 is put forward through studying casting characteristic of high-carbon steel and analyzing the reasons of sticking breakout.
通过研究高碳钢连铸特点,分析了高碳钢板坯连铸粘结漏钢的原因,提出了板坯连铸45#高碳钢保护渣优化设计思路。
2.
This article introduces the mechanism,main characteristic of sticking breakout.
介绍了大板坯连铸粘结漏钢的发生机理和和主要特点;结合邯钢三炼钢厂生产实践,分析了工艺、操作和设备等因素对粘结漏钢的影响;提出了降低粘结漏钢次数的主要措施。
5)  sticking breakout
粘连漏钢
1.
Hot rolled ribbon steel for container at Lai Steel is a newly developed steel type,and in this paper,the problems of longitudinal spilt,sticking breakout and the cold-bended split caused by endogenous inclusions,which are formed in continuous casting process,are analysed,and then measures have been taken,at last the quality defects are under control step by step,and satisfy the production demand.
莱钢热轧窄带集装箱钢是新开发耐候钢种,本文针对集装箱钢连铸生产中出现的纵裂、粘连漏钢及铸坯内部夹杂物造成的冷弯裂纹问题,通过分析原因,采取措施,逐步控制质量缺陷,达到生产要求。
6)  adhesive blockage
粘接堵漏
1.
The general methods and effect factors of adhesive blockage technique on-line operation with temperature and pressure were introduced.
介绍了化工设备带温带压粘接堵漏的常用方法及其影响因素。
2.
The paper briefly describes the application of adhesive blockage technique used in chemical production operation with temperature and pressure through examples.
结合实例,介绍了粘接堵漏技术在化工生产不停车状态时的应
补充资料:硫酸粘菌素 ,粘菌素,硫酸多粘菌素E
药物名称:多粘菌素E

英文名:Polymyxin E

别名: 多粘菌素E;可立斯丁;可刹迈仙干糖浆;硫酸抗敌素;硫酸粘菌素 ,粘菌素,硫酸多粘菌素E
外文名:Colistin ,Polymyxin E
性状:
常用其硫酸盐,为白色或微黄色粉末;无臭或几乎无臭。有引湿性。在水中易溶,在乙醇中微溶,在丙酮、氯仿或乙醚中几乎不溶。
药理作用:
抗菌谱和体内过程与多粘菌素B相同。口服不吸收,用于治疗大肠杆菌性肠炎和对其它药物耐药的菌痢。外用于烧伤和外伤引起的绿脓杆菌局部感染和耳、眼等部位敏感菌感染。注射已少用。
适应症:
用于治疗大肠杆菌性肠炎和对其他药物耐药的菌痢。外用于烧伤和外伤引起的绿脓杆菌局部感染和耳、眼等部位敏感菌感染。注射已少用。
用量用法:
1.口服:成人1次50万~100万单位,1日3~4次。儿童1次量25万~50万单位,1日3~4次。重症时上述剂量可加倍。 2.外用:溶液剂每毫升含1万~5万单位,氯化钠注射液溶解。
注意事项:
1.可发生皮疹、瘙痒等过敏症状。胃肠道有恶心、呕吐、食欲不振、腹泻等不良反应。 2.孕妇慎用。 3.口服宜空腹给药。
规格: 片剂:每片50万;100万;300万单位。灭菌粉剂:每瓶100万单位,供制备溶液用(1mg=6500单位)


类别:抗生素
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条