说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 含铁相
1)  Fe containing phase
含铁相
1.
The Fe containing phase in hypereutectic Al-2.
89%Fe(质量分数,%)合金中含铁相向样品的中心处富集。
2)  ferromagnetic phase content
铁磁相含量
1.
Furthermore, the deformation-induced martensite has strong effect on its pit corrosive sensitivity when the ferromagnetic phase content is low.
对不同程度低温形变的1Cr18Ni9Ti亚稳态奥氏体不锈钢在氧化物介质中孔蚀敏感性与铁磁相含量的关系进行了探讨。
3)  iron-bearing phase with square shape
方形含铁相
4)  containing Fe
含铁
1.
The new research progress in AB5-type rare earth based hydrogen storage alloys with low-Co and containing Fe was reviewed.
综述了近年来人们对提高AB5型低钴含铁贮氢合金综合性能所进行的探索。
5)  iron phase
铁相
1.
Effects of Refining Temperature on The Morphology of Iron Phase in Hypereutectic Al-5Fe Alloy;
精炼温度对过共晶Al-5Fe合金中富铁相形貌的影响
2.
Effects of Manganese on the Morphology of Iron Phase and Mechanical Properties of Al-Si Alloy with High Fe Content;
Mn对高铁铝硅合金中铁相形态和力学性能的影响
3.
The forms of iron phases and their influence on the structure and properties of magnesium alloys are introduced.
介绍了镁合金中铁相的形态及其对镁合金组织性能的影响,综述了含Mn、B、Zr、Ti等镁合金除铁剂的研究现状及消除和改善铁相形态的措施,分析了影响除铁效果的因素,指出了今后镁合金除铁的研究方向是高效并确保镁合金良好的综合性能。
6)  iron concentration
铁含量
1.
The uncertainty for determination of iron concentration in zinc-iron coating of galvaneal by chemical method was evaluated.
对用化学法测定锌铁合金钢板镀层铁含量测量结果的不确定度进行评定,分析了该方法测定过程的不确定度来源主要是分析锌铁合金钢板镀层中铁质量的不确定度和分析锌铁合金钢板镀层质量的不确定度,建立数学模型并计算了各不确定度分量,经合成得标准不确定度为0。
2.
Therefore, iron concentration could be calculated according to Beer's Law.
采用分光光度法,以磺基水杨酸为显色剂,乙酸铵、乙酸为缓冲剂,过硫酸铵为氧化剂测定锌铁合金电镀液的吸光度,并根据比耳定律计算铁含量。
3.
It is found that the iron concentration measured by SPV in oxidized wafers decreases dramatically after 3 min of RTA at 1100℃.
结果表明,氧化硅片在1100℃的条件下RTA 3min后,SPV测出的铁含量大幅度地减小。
补充资料:钨铁电炉出铁(吉林铁合金厂)


钨铁电炉出铁(吉林铁合金厂)


  吻 他排由帕中桩了士朴屏人乙曰“
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条