1) explosion container
爆炸容框
1.
Through the experimental research on explosive forming of heating panel with annular recess,the forming mechanism of large size plate part in explosion container is briefly introduced.
通过对带环形槽散热板的爆炸成形的实验研究,简要介绍了大尺寸板状零件在爆炸容框内进行成形的机理,并对其实验方法、装置、过程以及能量、药量估算进行了分析。
2) explosive containment vessel
爆炸容器
1.
Analysis of dynamic elastic response of flat ribbon wound explosive containment vessel;
扁平绕带式爆炸容器的弹性动力响应分析
2.
By using the HS2 high strength fiberglass and 0Cr18Ni9 stainlesssteel, one spherical and cylindrical resin matrix fiberglass composite explosive containment vessel with 500mm inner diameter have been designed.
采用HS2高强玻璃纤维及0Cr18Ni9不锈钢内衬,设计了内径500mm的球形及柱形树脂基玻璃纤维复合材料爆炸容器,容器通过了6MPa的水压试验和系列爆轰加载考核实验,炸药与球形及柱形容器的质量比分别达到3。
3.
According to the physical and mechanical character of explosive containment vessel, a set of virtual instrument system based on ISA bus and TOP View 2000 software for measuring the dynamic strain of the vessel has been built.
根据爆炸容器的具体物理及力学结构特点,建立了一套基于ISA总线和TopView2000软件的爆炸容器动态应变虚拟仪器测试系统,运用应变计的双片重叠安装、密封屏蔽接线和隔离电源等综合技术实现了强电磁干扰环境下的动态应变精密测量。
3) explosion-containment vessel
爆炸容器
1.
The paper described the design method of explosion-containment vessel and an explosion-containment vessel with 5 kg TNT equivalent was designed by this method.
介绍了爆炸容器的设计方法 ,用此方法设计了一台 5kgTNT当量爆炸容器并对该容器进行了动态测试 ,测试结果表明 :该容器设计合理 ,工作安全、可
2.
The first explosion-containment vessel with 1kg TNT equivalent made of the clad metal materials was introduced in this paper.
并应用爆炸相似律、解析方法及数值模拟等方法对该爆炸容器进行了物理设计 ,确定出等效载荷 ,然后进行了机械设计。
3.
The reflected shock pressures on the inner wall of the spherical explosion-containment vessels are calculated by the Eulerian method in the DYTRAN code.
运用ＤＹＴＲＡＮ程序中的欧拉计算方法，模拟了作用于球形爆炸容器内壁的反射超压波形。
4) explosion vessel
爆炸容器
1.
A new explosion vessel used to recover warhead fragments and its application;
回收战斗部破片的新型爆炸容器及应用
2.
Theoretical Analysis of and Experimental Research on the Vibration Characteristics of Cylindrical Explosion Vessel;
柱形爆炸容器振动特性的理论分析与实验研究
3.
Based on the Donnell theories,the formula for the inherent frequency of the cylindrical explosion vessel is derived.
根据唐纳尔简化理论,推导了柱形爆炸容器固有频率的计算公式。
5) explosion containment vessel
爆炸容器
1.
Strain measurement and analysis of explosion containment vessel under hydrostatic test;
真实爆炸容器水压应变测试及分析
2.
Explosion containment vessels(ECVs) are used to fully contain the effects of high explosions.
爆炸容器是一种潜在危险的限域装置,它能限制爆炸冲击波和产物的作用范围,为试验人员和设备提供有效的近距离保护,方便对爆炸和爆轰过程进行观察和测试,以及回收试验产物、防止环境污染等。
3.
The measured results of radial deformation of the explosion containment vessel under internal.
本文利用激光多普勒效应原理,研制了激光多普勒动态位移测量系统,实现了非接触固体表面的径向动态位移测量,通过对爆炸容器在内部加载作用下产生的径向变形的测量检验,获得了爆炸容器弹性、塑性变形条件下的位移曲线,结果证明激光多普勒位移测量系统在响应频率、信号的强度、测量距离、量程等方面满足爆炸容器径向变形测量要求。
6) BLAST CHAMBER
爆炸容器
1.
An evaluation method was proposed for the design and the life- span of use of blast chamber for break out affair,and the JBG series blast chambers had been designed and built up for resisting 1.
提出了应付突发事件用爆炸容器的设计方法和使用寿命的评估方法,对JBG系列抗爆球罐在爆炸载荷作用后的残余变形进行了计算,评估了多次重复载荷条件下的使用寿命,残余变形的验证实验结果与计算结果基本一致。
补充资料：核爆炸地震波探测(见核爆炸探测)
核爆炸地震波探测(见核爆炸探测)
nuclear explosion seismic detection
hebaozho dizhenbo tanee核爆炸地震波探测(nuclear explos，onseismie detecuon)见核爆炸探汉，l。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条