1) Phase-transformation-cooling
锡冷铜模
1.
Effects of Phase-transformation-cooling Method on Microstructure of A356 Cast Aluminum Alloy;
锡冷铜模对铸造A356铝合金组织的影响
2) Water-cooling in Cu Mould
水冷铜模
3) tin-copper
锡铜
1.
This paper investigated the effects of high magnetic field on the growth behaviors of tin-copper intermetallic compounds (IMC) layers.
研究了强磁场对锡铜界面金属间化合物生长行为的影响,研究了Sn/Cu钎焊和扩散焊焊接界面处金属间化合物的生长行为,同时也研究了Sn-3Ag-0。
4) CuPbSn bronze
铜-铅-锡青铜
5) tin bronze
锡青铜
1.
Centrifugal Casting Technology for HighQuality Tin Bronze Sleeve;
离心铸造优质锡青铜套筒工艺
2.
Evaluation of uncertainty in the determination of Sn in tin bronze by photoelectric direct reading spectrometry
光电直读光谱分析法测定锡青铜中锡不确定度的评定
3.
The effects of Zn, Sn on properties and microstructure of vacuum casting tin bronze were studied.
用相同质量的锌代替部分锡,研究了Zn、Sn对真空铸造锡青铜合金性能和组织结构的影响。
6) Cu-Sn alloy
铜锡合金
1.
Electroplated Cu-Sn alloy coating is good in decoration and solderability,low in cost,non-toxic,not irritable,etc.
电镀铜锡合金具有装饰性好、可焊性优良、成本低、无毒、不使人体过敏等优点,而得到广泛的应用。
2.
The method use SCR continuous casting-rolling system to make conducting wire(Cu-Sn alloy rod) for railway application was introduced.
介绍了采用SCR连铸连轧生产线生产高速电气化铁路接触网线用铜锡合金线坯的方法,用该法生产的产品,具有内部组织细小,均匀的晶粒,强度高,软化温度高,平直度好,耐摩性好,抗蠕变性好等特点。
3.
The paper describes the process ofφ20mm Cu-Sn alloy wirebar production in continuous casting and roiling process,analyzes the impact of the wirebar s oxygen and tin content distribution on production stability, describes the cold-forming process of contact wire manufacturing by drawing machine,and studies and compares anti-drawing strength and extension capability of it.
介绍了采用连铸连轧工艺生产φ20mm铜锡合金线坯的过程,分析了线坯氧含量、锡含量对生产稳定性的影响。
补充资料：长春冷弯型钢总厂生产的异形冷弯型钢
长春冷弯型钢总厂生产的异形冷弯型钢
长春冷弯型钢总厂生产的异形冷弯型钢
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条