1)  optical transmittance
光学透过
2)  transmittance
光学透过率
1.
The transmittance of CVDZnS before and after heat isostatic processing (HIP)was measured.
采用红外、紫外光谱仪对热等静压(HIP)处理前后CVDZnS的光学透过率进行了测量,采用分析电子显微镜、金相显微镜和X射线衍射对原生CVDZnS和经热等静压(HIP)处理的CVDZnS的显微组织和晶体结构进行了分析。
3)  optical transparency
光学透过率
1.
The effects of thickness, surface roughness and composition of optical transparency of diamond film are studied here.
研究了金刚石薄膜的厚度、表面粗糙度及其成分对金刚石薄膜光学透过率的影响,采用AFM观察金刚石膜的表面形貌并测试其表面粗糙度Ra值;用XPS仪测试了金刚石膜成分;用UV-365分光光度仪测试了光学透过率。
2.
Young s modulus and thermal conductivity The properties of films grown by MPCVD such asstress, surface roughness and optical transparency were discussed in accordance with the requirements of X-raylithography mask.
根据X射线光刻对基膜材料的要求,本文研究了微波等离子体CVD法生长的金刚石膜的应力、表面粗糙度、光学透过率。
4)  optical transmittance
光学透过率
1.
The optical transmittance and the sheet resistance of Cu films with different thickness were measured.
在室温条件下,用直流磁控溅射Cu靶制备出了不同厚度的Cu膜,测量了Cu膜的光学透过率和面电阻,分析了光电性质薄膜厚度的变化情况。
2.
Based on the measurement of XRD,SEM,AFM,Hall Effect,and optical transmittance and reflectivity,the characteristics of the thin films,including the crystal plane,optical transmittance,optical band gap energy,resistivity,roughness,were investigated.
通过X-射线衍射(XRD)、扫描电子显微镜(SEM)、透过率、反射率、电阻率和原子力显微镜(AFM)等测试分析,研究了材料生长温度和B_2H_6流速对薄膜生长速度、微观结构、薄膜晶向、光学透过率、光学禁带宽度、电阻率、表面粗糙度等特征参量的影响,经过优化实验条件,获得薄膜电阻率在10~(-3)Ω·cm量级,可见光区域光学透过率在85%以上,成功制备低电阻率高光学透过率的ZnO透明导电薄膜。
5)  Optical transmission
光学透过性
1.
Optical transmission is a key issue of the Thomson scattering system due to the weak scattered signal.
光学透过性能对信号微弱的激光汤姆逊散射测量系统极为重要。
6)  Enhanced optical transmission phenomena
增强光学透过现象
补充资料:紫外高透过光学玻璃
分子式:
CAS号:

性质:具有和某些无色光学玻璃相同的光学常数和理化性质,但紫外和可见光的透过率比一般的要高得多的光学玻璃。主要用于紫外光谱仪、光电器件,以及要求可见光透过率特别高的光学仪器、摄像镜头等。影响玻璃的紫外透过率的因素,除了玻璃基质的化学成分外,还取决于玻璃中的杂质,如Fe3+,Mn2+,Ce4+,Ti4+等杂质离子。因此生产紫外高透光学玻璃要选用高纯原料,在熔制时防止沾污。 

说明:补充资料仅用于学习参考,请勿用于其它任何用途。