1) equal-channel angular pressing (ECAP)
侧向等径挤压(ECAP)
2) ECAP
等径角挤压(ECAP)
3) ECAP(equal channel angular pressing)
ECAP(等径角挤压)
4) equal-cross section lateral extrusion
等径侧向挤压
1.
According to the moving direction relations between punch and workpiece,a new definition of lateral extrusion has been put forward,at the same time,the new concepts of compressing lateral extrusion,equal-cross section lateral extrusion and stretching lateral extrusion have been put forward too.
根据挤压方向和挤出方向之间的相互关系,对侧向挤压这一概念赋予了新的定义,同时也提出了扩径侧向挤压、等径侧向挤压和缩径侧向挤压3个新概念,进一步给出了等径侧向挤压真应变的计算公式,并指出等径侧向挤压法是制备块状细晶材料的一种好方法。
2.
In this paper,the strain of the equal-cross section lateral extrusion has been analyzed,and the true strain and equivalent true strain formulae are derived from the strain analysis of the plane-pureshear deformation.
对等径侧向挤压变形的应变进行了深入的分析，应用平面纯剪切变形应变分析的结果，得到了等径侧向挤压变形真应变和等效真应变的计算公式，分析了循环等径s型侧向挤压真应变和等效真应变的变化规律。
5) equal cross section lateral extrusion
等径侧向挤压
1.
Finite element analysis of deformation uniformity of equal cross section lateral extrusion;
等径侧向挤压变形均匀程度的有限元分析
2.
In this paper,the curves of load verses displacement during equal cross section lateral extrusion process have been measured and calculated by FEM respectively,the calculated results are in good accordance with the measured results.
本文对等径侧向挤压过程中载荷的变化， 分别进行了实测及有限元模拟计算， 两种结果吻合较好。
6) compressing lateral extrusion
扩径侧向挤压
1.
According to the moving direction relations between punch and workpiece,a new definition of lateral extrusion has been put forward,at the same time,the new concepts of compressing lateral extrusion,equal-cross section lateral extrusion and stretching lateral extrusion have been put forward too.
根据挤压方向和挤出方向之间的相互关系,对侧向挤压这一概念赋予了新的定义,同时也提出了扩径侧向挤压、等径侧向挤压和缩径侧向挤压3个新概念,进一步给出了等径侧向挤压真应变的计算公式,并指出等径侧向挤压法是制备块状细晶材料的一种好方法。
补充资料：向外等
【向外等】
（术语）(参见：向内等)
（术语）(参见：向内等)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条