2) thermo-mechanical simulation
热力模拟
1.
A heating process with self-resistance was introduced in the rapid heating system for metal materials during the test of thermo-mechanical simulation.
针对热力模拟实验中金属材料快速加热系统,采用直接电阻加热方式,分析了加热速度的估算方法;为克服大电流所形成电磁场对温度测量的影响,采用每10ms周期短暂断电采集温度策略,利用同步电压实现触发采集,提出当采集点偏离断电区时的判断方法,并重新设置触发时间·介绍了智能控制在快速加热系统的应用·实践表明,快速加热系统在快速升温的同时,具有采集温度准确、控制精度高的特点
3) heat/force simulation
热/力模拟
6) thermodynamic modeling
热力学模拟
1.
A thermodynamic modeling for controls of deoxidation and oxide inclusion in molten steel was developed based on these calculations, which was used for thermodynamic calculations for deoxidation, slag-melt equilibration and oxide-melt equilibration in order to control the deoxidation and compositions of oxide inclusion of steel.
在钢包精炼的渣-金平衡条件下钢液硅脱氧和铝硅脱氧后钙处理的工业性实验,以及钢液凝固过程形成的钢中氧化物夹杂分析结果说明,该热力学模拟方法可用于钢包精炼中钢液的脱氧控制和钢中氧化物夹杂控制。
2.
A thermodynamic modeling is developed for slag-metal equilibration in LF, deoxidation control of the melt and prediction of composition of oxide inclusion in steel based on the sub-regular solution model of multi-component system.
本文基于多元系亚正规溶液模型建立了钢液脱氧控制的热力学模拟方法,并应用于钢包精炼中渣-金平衡、脱氧控制和钢中氧化物夹杂成分预测。
补充资料：轧辊残余应力(见轧辊应力)
轧辊残余应力(见轧辊应力)
residual stresses in roll
zhagun eanyu yingli轧辊残余应力(residual stresses in roll)见礼辐应力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条