2) Fe-Al coatings
铁铝涂层
1.
The endurance of Fe-Al coatings in liquid Zinc bath was studied it confirmed that the DGS coating was better than the HVOF.
在 45 #钢基体上 ,采用高速火焰喷涂 (HVOF)法和气体爆燃喷涂法 (DGS) 2种不同的工艺方法 ,分别喷涂铁铝涂层 ,观察涂层的微观组织 ,并分析其相结构及截面组织的不同 。
3) Fe-based coating
铁基涂层
1.
In this paper, the parameters of supersonic plasma spraying Fe-based coatings were optimized according to orthogonal design method, 9 orthogonal experiments were conducted.
结果表明喷涂参数可以在很大程度上影响涂层的性能,通过综合评分对涂层的综合性能进行了分析,得到了超音速等离子喷涂制备铁基涂层的优化参数,并进行了追加验证实验,结果表明正交优化提高了再制造涂层的综合性能。
4) coated cast-iron pipe
涂层铸铁管
5) iron sol coating
铁溶胶涂层
1.
The thin and uniform iron sol coating on carbon fibers is prepared by coating iron sol.
采用铁溶胶对碳纤维的成膜性进行了研究,分别考察了碳纤维脱胶工艺和铁溶胶涂层碳纤维热处理工艺对铁溶胶成膜性的影响。
6) FeS coating
硫化亚铁涂层
1.
The powder of FeS,with granularity of 40μm for spraying,was prepared by ball-mill method,and then the FeS powder was sprayed by ultrasonic flame spraying to form the solid lubrication FeS coating on the 45 steel surface.
利用球磨方法得到用于喷涂的、粒度约40μm的硫化亚铁(FeS)微颗粒,再用超音速火焰喷涂的方法在45钢表面制备了固体润滑硫化亚铁涂层。
补充资料：钨铁电炉出铁(吉林铁合金厂)
钨铁电炉出铁(吉林铁合金厂)
吻 他排由帕中桩了士朴屏人乙曰“
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条