说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 衬砌
1)  lining [英]['laɪnɪŋ]  [美]['laɪnɪŋ]
衬砌
1.
Construction technology of lining concrete in a certain diversion tunnel;
某导流隧洞衬砌混凝土施工技术
2.
The study on the influence on the behavior of insufficient thickness of roof lining in Baishanzui tunnel structure;
白山嘴隧洞顶拱衬砌厚度不足对结构性态影响研究
3.
Dynamic stress concentration of SH-waves by arc cracks near a circular lining;
SH波作用下弧形裂纹对圆形衬砌动应力集中系数的影响
2)  liner [英]['laɪnə(r)]  [美]['laɪnɚ]
衬砌
1.
Experimental research on clogging of mat base of inside and outside liner of Yellow River-crossing tunnel by concrete construction
混凝土浇筑施工对穿黄隧洞衬砌垫层渗透性影响试验研究
2.
Scattering around a liner of arbitrary shape in saturated soil under dilatational waves
饱和土中任意形状衬砌对稳态压缩波的散射
3.
Analyzed the affect of the concrete hydration heat on distribution of temperature and stress field of artificial ice wall while excavating a pit and then pouring mass concrete liner after temperature field of artificial ice is forming.
研究了在人工冻土墙形成并达稳定温度场分布呈非线性后,基坑开挖并浇注大体积混凝土衬砌时,混凝土水化热对冻土墙温度场及其耦合应力场分布的影响,分析得出了在冻土墙温度场分布改变过程中,其与内衬共同作用应力场的变化规律。
3)  tunnel lining
衬砌
1.
Study on analytical solution method of circular tunnel lining and surrounding rock stress;
圆形隧道衬砌与围岩应力的解析法研究
2.
In the light of the drawbacks met in the double-layer lining in soft rock strata,permanent tunnel lining by single-layer reactive powder shotcrete is studied by using numerical simulation and test.
通过试验和数值模拟分析,研究了隧道喷射活性粉末混凝土单层衬砌支护技术。
3.
By applying the method of mechanics and combined with the construction situation of railway tunnels,the analysis on the loading situation of the structure of the formworked concrete lining in the single track railway tunnel with the surrounding rock of above Ⅳ class has been put forward,and the comparisons with the actual situation of cracks on the tunnel lining are put forward also in this paper.
文章运用力学方法结合铁路隧道施工情况 ,对单线铁路隧道 类及以上围岩模筑混凝土衬砌结构受力情况进行了分析 ,并与衬砌裂纹实际情况进行了对照比较 ,阐明了衬砌微裂纹产生的原因 ,提出了避免裂纹产生的建
4)  mortar laid stone lining
浆砌石衬砌
1.
The application of mortar laid stone lining in canal seepage control and countermeasures;
浆砌石衬砌在渠道防渗中的应用及对策
5)  explosive lining
爆炸衬砌
1.
Influence of explosive enlargement and explosive lining on moisture content of soil;
爆炸成腔与爆炸衬砌对土体含水率的影响
2.
Using DYNA 2D commercial program, the change of displacements of mortar and soil with time during the explosive lining are analyzed by numerical simulation.
将爆炸衬砌简化为轴对称问题。
3.
Explosive lining process is numerically simulated by DYNA-2D finite element program, and the time history of stress distributions in the fluid mortar during explosive lining is analyzed.
应用DYNA-2D有限元程序,对爆炸衬砌过程中流态砂浆内的应力变化进行了数值模拟研究。
6)  lining tunnel
衬砌隧洞
1.
Here in China in the field of engineering exploration we do not have feasible m ethods for drilling and sampling in lining tunnel.
但是 ,在衬砌隧洞内钻探和取样国内尚未有确实可行的方法。
补充资料:复合式衬砌
      分内外两层先后施作的隧道衬砌。在坑道开挖后,先及时施作与围岩密贴的外层柔性支护(一般为喷锚支护),也称初期支护,容许围岩产生一定的变形,而又不致于造成松动压力的过度变形。待围岩变形基本稳定以后再施作内层衬砌(一般是模筑的),也称二次支护。两层衬砌之间,根据需要设置防水层,也可灌筑防水混凝土内层衬砌而不做防水层。
  
  复合方式  复合式衬砌的外、内层复合方式有以下几种:喷锚支护和混凝土衬砌;喷锚支护和喷射混凝土衬砌;可缩式钢拱喷射混凝土支护和模筑或喷射混凝土衬砌,以及装配式衬砌(管片)和模筑混凝土衬砌等。最通用的是外层采用喷锚支护或轻型管片,内层采用整体式模筑混凝土衬砌(见图)。
  
  
  防水层  两层衬砌间的防水层,可采用喷涂乳化沥青等防水胶剂,或采用厚度不等的软聚氯乙烯薄膜、聚异丁烯片、聚乙烯片等防水卷材,并固定在支护上。为保证防水卷材施工接缝的质量,一般需要用热气焊接或电阻焊接,亦可用适当溶剂作溶解拼接。
  
  施工  复合式衬砌施工中的一个重要环节是喷涂或粘贴防水层,要求做到与初期支护相密贴,故在防水层施工前需要对初期支护的表面进行适当处理,使其平整圆顺,无较大渗水。初次支护的施工方法和要求,与一般喷锚支护或装配式衬砌的相同。内层模筑衬砌多采用模板台车和混凝土泵进行连续灌筑。
  
  设计  复合式衬砌中,外层支护与围岩形成统一的受力整体,共同承担因开挖坑道所产生的围岩释放应力。由于影响共同作用的因素很多,如围岩状态、支护施作时间、衬砌刚度和施工方法等,有些因素事先又无法预测,故分析计算只能作为设计时参考,必须根据施工过程的量测结果予以修正。内层衬砌主要为了防水、防风化、内部装饰和增加安全度,其厚度按施工要求而定,一般不超过40厘米。有时不易做到待初期支护变形完全稳定后再施作内层衬砌。例如当松软围岩流变引起的延滞变形历时很长时,这时内层衬砌所承受的荷载主要是由于围岩延滞变形产生的形变压力;以及因部分锚杆腐蚀失效,或涌水降低了围岩物理力学参数所引起的附加岩土压力。
  
  复合式衬砌的优缺点  采用先后两次支护,对衬砌受力非常有利。围岩在柔度较大的外层支护条件下,可产生较大的形变,释放了大部分的变形能;因而能使后设的内层衬砌减小受力。内层衬砌施作以后,又会对原先处于二维受力状态的外层支护产生径向抗力,从而改善外层支护的受力条件。而且表面光洁平整,有利于隧道通风和防水,并保护外层支护,使喷层内钢筋网和锚杆端部免于锈蚀。但是,这种衬砌的缺点是造价较高,施工也比较复杂。
  

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条