说明：双击或选中下面任意单词，将显示该词的音标、读音、翻译等；选中中文或多个词，将显示翻译。 您的位置：首页 -> 词典 -> 过盈挤压 1)  interference extrusion 过盈挤压 1. Starting from the principle of the metal plastic deformation, this paper discusses on the design of rigid rebound bending die, which includes the comparison of the die structure, and the selection and the calculation of the magnitude ofthe interference extrusion, etc. 从金属塑性变形原理出发,论述了无弹性回跳弯曲模的设计,包括模具结构对比、过盈挤压量的选择和计算。 2)  extruding magnitude of interference 挤压过盈量 3)  force fit 过盈压入 1. 1%force fit level i s best for prolonging fatigue life of jointing structure. 过盈压入是提高孔连接结构抗疲劳破坏能力的经济而有效的措施。 4)  Pinch pressure 过盈压力 5)  extrusion process 挤压过程 1. Numerical simulation of extrusion process of AZ31 magnesium alloy tubes; AZ31镁合金管材挤压过程的数值模拟 2. Numerical simulation of the extrusion process by an adaptive element-free galerkin-finite element(EFG-FE) coupling method 挤压过程自适应耦合无网格-有限元法数值模拟 3. All the methods for analyzing food extrusion process fall to 6 classes,two of which,residence time distribution(RTD) analysis and rheology analysis are presented in this paper. 挤压过程的分析方法分为6种,着重介绍RTD分析和流变分析2种方法。 6)  hydraulic pressure excessively full connection 液压过盈连接 1. The principle and structural character of main reducer gear taper-bushing hydraulic pressure excessively full connection device of rolling-cut double trimming shear were described in this paper,including its mechanics analysis and calculation. 阐述了滚切式双边剪主减速箱齿轮锥套液压过盈连接装置的结构特征及其工作原理,并对其进行了力学分析和计算。 补充资料：相盈 1.互相包含。 说明：补充资料仅用于学习参考，请勿用于其它任何用途。 参考词条 ©2011 dictall.com