1) dry compression set
干压缩变形
2) shrinkage deformation
干缩变形
1.
Finite element simulation based on microscopic mechanism of concrete shrinkage deformation;
基于微观机理的混凝土干缩变形有限元模拟
2.
Value of shrinkage deformation under different humidity is recorded by micrometer gauge.
主要研究了水泥用量、胶凝材料类型、引气量、砂率等因素对混凝土干缩变形的影响。
3) drying shrinkage
干缩变形
1.
Based on comparing tests between the drying shrinkage of small type concrete block packed wall at different air hummidity and different restraint condition of steel bar length,the effect of the level-direction pulling steel bar on the drying shrinkage of small type concrete block packed wall were studied.
通过不同湿度和不同拉结钢筋长度约束条件下混凝土小型砌块填充墙体干缩变形的对比试验,研究了水平拉结钢筋对砌块填充墙干缩变形的影响,并作了相应的机理分析。
4) dry shrinkage deformation
干缩变形
1.
The article analyzes the main causes of cracks in air-entrained concrete wall from dry shrinkage deformation of air-entrained concrete building block and mortar,temperature fluctuation,settlement deformation of masonry and irrational building structure,and proposes measures to control wall cracks,in order to ensure normal utilization and security of wall.
从加气混凝土砌块及砂浆干缩变形、温度变化、砌体沉缩变形、建筑物构造不合理等方面分析了引起加气混凝土墙体产生裂缝的主要原因,并提出了控制墙体开裂的措施,以保证墙体的正常使用及其安全性。
2.
The article introduces the concept of waterproofing for subway station with sandwich structure and analyses the temperature stress on side wall concrete and the dry shrinkage deformation and volume deformation of the concrete with some conclusions on causes for side wall cracking.
介绍了地铁叠合结构车站防水的基本概念,对地铁叠合结构车站侧墙混凝土所受的温度应力、混凝土干缩变形、自身体积变形等进行了分析研究,得出了产生侧墙裂缝原因的几点结论。
5) Shrinkage
[英]['ʃrɪŋkɪdʒ] [美]['ʃrɪŋkɪdʒ]
干缩变形
1.
The experimental samples are formed firstly,then unrestrained compression strength、resilience modulus、shrinkage are tested.
采用规范建议的级配加入分别为４％、５％、６％、８％的水泥剂量，制成标准试件经规定的养护后，在不同龄期进行无侧限抗压、回弹模量、干缩变形等试验。
6) Compression Deformation
压缩变形
1.
Compression Deformation Behavior of Semi-solid Y112 Aluminum Alloy;
半固态Y112铝合金的压缩变形力学行为
2.
Mechanical properties of A2017 alloys compression deformation in semi-solid state;
A2017合金半固态压缩变形力学特性
3.
Compression Deformation Behavior of Semi-solid Al-Si Alloy Prepared by Crystallization-controlling;
控制结晶法制备半固态铝合金的压缩变形特性
补充资料：高温压缩永久变形试验
分子式：
CAS号：
性质：考察橡胶制品在高温压缩状态下永久变形的试验。测定时将试样进行一定压缩后，放在高温下保持一段时间，然后在室温下冷却2h，除去负荷后再自由恢复1h，最后测定试样高度，高温下压缩永久变形率K由下式计算。式中，h0、h1、h2分别为压缩前压缩下和恢复后的试样高度。
CAS号：
性质：考察橡胶制品在高温压缩状态下永久变形的试验。测定时将试样进行一定压缩后，放在高温下保持一段时间，然后在室温下冷却2h，除去负荷后再自由恢复1h，最后测定试样高度，高温下压缩永久变形率K由下式计算。式中，h0、h1、h2分别为压缩前压缩下和恢复后的试样高度。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条