1) entrance finishing temperature
精轧开始温度
2) the beginning and end temperature of steel plate at the finishing mill
精轧开终轧温度
3) initial rolling temperature
开轧温度
1.
The rolling results and performance analysis showed that the initial rolling temperature should be controlled from 1 100 ℃ to 1 180 ℃, If the temperature is higher than 1180 ℃, the rolled piece will be difficult to be bitted;if the temperature is below 1 100 ℃, the steel tend to thermal crisp and the head of rolled piece is easy to crack.
轧制结果及性能分析表明,开轧温度控制在1100～1180℃范围内较好,高于此温度范围轧制时会出现轧件打滑,咬入困难现象,温度低于此范围,钢容易发生热脆,轧件头部易开裂。
4) pre-finishing temperature
预精轧温度
1.
Few network carbides and fine laminar pearlite were obtained in the industrial experiment on increasing the pre-finishing temperature of GCr15 bearing steel 10 mm wire,and heat simulation method was used in laboratory to analyze industrial experiment phenomena.
通过提高GCr15轴承钢10 mm线材预精轧温度的工业试验,得到了网状碳化物少的细片状珠光体组织,利用实验室热模拟的方法对工业试验现象做了进一步分析。
5) initial temperature of rolling
初始轧制温度
6) exit temperature at finishing
精轧出口温度
补充资料：初轧温度规程
初轧温度规程
temperature schedule of blooming mill
ehuzha wendu guieheng初轧温度规程(temperature seheduze ofblooming mill)在初轧机上将钢锭轧成钠坯时的温度方案。包括加(均)热温度、出炉温度、开轧温度、终轧温度、剪切温度和冷却方式等。 钢锭的加热温度与钢种有关。钢锭因含碳量(及含合金量)不同，加热上限温度不同，加热速度也不同。通常按含碳量把钢锭分成三组，分别规定它们的加(均)热温度即最高控制炉温和出炉温度. 第一组:含碳量C(。.3%的低碳钢，最高控制沪温为1380℃，出炉锭温为 1180一1220℃;第二组;含碳量。.3%
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条