1) water collecting equipment
集水装置
2) water-collecting
集水
1.
Exploration of the Discussion on the Ways of Building Water-collecting Green Space in Beijing;
北京集水型公园绿地建设探讨
3) rainwater harvesting
集水
1.
On the basis of natural conditions of lack of rainfall on the Loess Plateau, this paper presents a method of design and construction in rainwater harvesting system for afforestation, which is suitable to the regions of 300 600?mm rainfall.
根据黄土高原地区降水缺乏的自然条件 ,该文提出了 30 0mm到 6 0 0mm地区用于造林的集水设计与施工方法 。
4) catchment
集水区
1.
CFD study on effect of catchment area on hydraulic performance of subsurface flow constructed wetland;
用CFD研究潜流人工湿地集水区对其水力学性能的影响
2.
An individual-based catchment scale forest dynamic model;
基于个体的集水区森林动态模型
3.
Effects of land-use pattern change on soil and water loss at the catchment scale in the hilly and gully area of the loess plateau of China;
黄土丘陵沟壑区集水区尺度土地利用格局变化的水土流失效应
5) enrichment level
富集水平
1.
For all the five soilless cultivated vegetables of the polluted water,enrichment level of metal elements was found different.
结果表明,污染水体中水培蔬菜的金属元素富集水平是不同的。
6) water station
集水站
1.
There is a water station at land of water source at Hanan Lake of Xinjiang.
在新疆哈南湖水源地,建有集水站。
参考词条
补充资料:地下水集水构筑物
地下水集水构筑物
groundwater collecting structure
d*x旧shui Jishu一gouzhuwu地T水集水构筑物(groundwater eolleetingstruct盯e)为地下水开采构筑的从含水层中采取地下水的设施。地下水集水构筑物分垂直和水平两类。垂直集水构筑物有管井、大口井等一水平集水构筑物有渗渠。也有二者结合使用的集水构筑物,如辐射井。 管井采用较多的地下水垂直集水构筑物。用钻机钻入含水层下套管和过滤器(见管井施工)成井。它适用于埋藏较深、厚度较大的含水层。井管材料一般采用钢管、铸铁管、混凝土管或塑料管等。井的直径和探度根据水文地质条件和井的出水量等因素确定。通常井的直径在。.sm以内,井的深度在几十米至几百米不等。井管由井壁管、过滤器和沉淀管组成。井壁管下泵部位的内径至少比抽水泵吸水设备的外径大0.05m。过滤器外径按允许入管流速复核,其计算公式为: 。、Q D派-一生二二 一一冗乙nVg式中D为过滤器外径,m;Q为设计出水量,m“/s;L为过滤器工作部分长度,m;n为过滤器表面有效孔隙率;V:为允许入管流速,m/s。过滤器类型可根据含水层的性质选用(见表)。 填砾过滤器的填砾规格可按下列规定确定:(l)砂类含水层,DS。=(6一8)ds。;(2)砾类土含水层,当dZ。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。