1) normal anisotropy
厚向各向异性
1.
A large deformation elastic-plastic FEM model was built by introducing Mindlin shell element to incremental virtual work principle and considering the normal anisotropy of sheet.
将Mindlin曲壳单元引入基于逐级更新的虚功率增率型原理,考虑板材的厚向各向异性,建立了大变形弹塑性有限元模型。
2.
With the total strain theory and membrane assumption and taking the normal anisotropy of sheet metal into consideration,initial blank size can be directly calculated from desired flanging height.
在该算法中,采用了全量塑性理论及膜应变假定,并考虑了板材的厚向各向异性,可以直接从所需的翻边高度计算出初始坯料的尺寸。
3.
The Bauschinger effect and the normal anisotropy and strain rate sensitivity to establish the model for solving the drawbead restrain forces.
考虑厚向各向异性、应变率、弹性力和应变硬化的影响,根据平面应变假设采用弹塑性幂次强化模型求解拉延筋约束阻力,并将结果与试验值对比,从而验证了此改进方法的有效性。
2) anisotropy
[,ænai'sɔtrəpi]
各向异性
1.
The asymptotic analysis of interfacial stability with surface tension anisotropy for directional solidification of alloys;
各向异性作用下合金定向凝固界面稳定性的渐近分析
2.
The elastic wave propagation in two-dimensional phononic crystal at low frequencies and the anisotropy of effective velocity;
长波条件下二维声子晶体中的弹性波传播及各向异性
3.
Measurements of magnetic parameter and calculation of anisotropy on carbon fiber with magnetic coating;
具有磁性涂层的连续碳纤维基本磁特性研究及其各向异性计算
3) anisotropic
[英][æn,aisə'trɔpik] [美][,ænaɪsə'trɑpɪk]
各向异性
1.
Constitutive relationships and application of anisotropic viscous materials;
粘性各向异性材料的本构关系及应用
2.
Study on the constitutive equation of anisotropic viscous materials;
粘性各向异性材料本构方程的研究
3.
Study of stress-strain analysis for anisotropic materials;
各向异性材料应力应变分析方法研究
4) anisotropism
[英][,ænai'sɔtrəpizəm] [美][,ænaɪ'sɑtrəpɪzəm]
各向异性
1.
Direct shear test study of anisotropism to Guangzhou soft clay
广州软土各向异性直剪试验研究
2.
Based on anisotropism theory, the technique of fracture detection by multi-component converted wave develops rapidly in recent years, and has started to be used in practical exploration of fractured reservoirs.
基于各向异性理论的多分量转换波裂隙探测技术近年来发展较快 ,已开始应用于裂缝性油气藏的勘探实践之中。
3.
One is an existing inconsistency between the hypothesis and the potential applied in vertical radial flows, the other is a conditional formula in anisotropism formation.
通过坐标变换 ,以及垂直流动面和水平流动面选取不同的渗透率 ,对Joshi水平井产能公式进行修正 ,提出了一个新的渗透率各向异性储层水平井稳定产能公式。
5) anisotropic property
各向异性
1.
The results showed that the values of strength(YS & TS)and yield ratio of specimens in the transverse direction were larger than that of specimens in the longitudinal direction and the anisotropic property was in agreement with the {112}〈110〉ideal orientation.
结果表明,横向试样的强度值大于纵向试样,该各向异性特征取决于{112}〈110〉织构强度;板状试样的强度值、伸长率均高于圆棒试样;另外,随着卷取温度的升高,圆棒试样的屈服强度呈先增后减的趋势;随着回火温度的升高,圆棒试样的屈服强度增量增大,并且纵向增量比横向大。
6) anisotropic material
各向异性
1.
Stress intensity factors near crack tip of anisotropic material with a new hybrid finite element method;
一种新的计算各向异性材料裂纹尖端应力强度因子杂交元法
2.
A new non-conforming finite element FE eigenanalysis method is developed to determine the order and angular variation of singular stress states at material and geometric discontinuities in anisotropic materials subject to antiplane shear loading.
提出采用一种非协调元有限元特征法来计算各向异性材料在反平面剪切载荷作用下的奇性应力指数和奇性场角分布。
3.
In this paper, an general analytical formulation is developed for the equivalent electric or magnetic current on stratified anisotropic material backed by metal surface based on a first order state vector differential representation of Maxwell′s equations.
基于Maxwell方程的一阶状态矢量微分方程描述 ,推导出均匀平面波入射下金属衬底多层各向异性材料表面上等效电磁流的一般解析表达式及其相互关系 ,以此为基础给出了两层涂覆电大尺寸平板导体的散射结果 ,为多层各向异性材料涂覆导体目标电磁散射的近似计算提供了理论基
补充资料：向秀
| 向秀（约227～272） 中国魏晋时期玄学家。字子期。河内怀（今河南武陟）人。主要活动时期为魏末晋初。向秀与嵇康、阮籍、山涛、王戎、阮咸、刘伶并称为竹林七贤。向秀早年淡于仕途，有隐居之志。嵇康被司马昭杀害后，为避祸计，不得已而出仕，先后任散骑侍郎、黄门侍郎 、散骑常侍等职 。主要著作有《庄子注》，但全作已佚，少量佚文保存在张湛《列子注》、陶弘景《养生延命录》、陆德明《经典释文》、李善《文选注》等著作中。向秀还著有《周易注》，该书序纵切面亦佚，唐李鼎祚《周易集解》中有部分佚文，清马国翰《玉函山房辑佚书》中有辑本。又有《难养生论》一篇，存《嵇康集》中；《思旧赋》一篇存《文选》和《晋书》本传中。清严可均辑《全晋文》卷72，录有上述二文。由于著作大都佚失，很难窥见其思想全貌。向秀合“自然”与“名教”为一的思想对以后郭象宣传“名教”即“自然”的思想有所启发。 |
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条