1) swinging cylinder
摆动油缸
1.
Plan analysis for the swinging cylinder in the hydraulic wrench;
液压扳手摆动油缸机构方案分析
2.
For the swinging cylinder type of hyd raulic wrench,through the analysi s and calculation for the locating parameters of its executive mechanism,formul a and design precondition of the lo-cating parameters are presented,wi th whic h the minimum of pushing force of the oil cylinder can be achieved under definit e swinging angle and given loosening &tighteni ng torque for the fasteners.
通过对摆动油缸式液压扳手机构位置参数的分析推导,得出其位置参数的计算公式和设计条件。
2) rh swing cylinder
右摆动油缸
3) Rifle swing hydraulic cylinder
螺旋摆动油缸
4) Rocker oil cylinder mechanism
摆动油缸机构
5) mechanism of oil cylinder oscillating with double actions
双作用摆动油缸机构
6) pneumatic rotary actuator
摆动气缸
1.
The typical nonlinear characteristics of the pneumatic rotary actuator position servo system using proportional flow valves are experimentally studied.
该文通过大量实验对比例流量阀控摆动气缸位置伺服系统的典型非线性特性进行了研究,主要包括:研究分析了工作点位置、负载大小、摆动气缸两腔初始压力等工作参数对系统特性的影响;指出了系统存在的粘滑振荡、位移波动、"停滞"等现象,并分析了其产生的原因。
2.
A pneumatic rotary actuator angular position servo system is studied,which adopts 3-port proportional flow valve as a control device.
该文对三通比例流量阀控制的摆动气缸转角位置伺服系统进行研究。
补充资料：油缸齿条抽弯头
|
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条