1) steel belt
钢丝带束层
2) steel belt compound
钢丝带束层胶
1.
The application of epoxidized trans-1,4-polyisoprene(ETPI) in the nylon carcass ply compound and steel belt compound of radial tire was investigated.
研究环氧化反式 1,4 聚异戊二烯 (ETPI)在轮胎锦纶帘布层胶和钢丝带束层胶中的应用。
3) steel wire
钢丝
1.
Application of complex HCl pickling in production of steel wire hotdip galvanizing;
复合盐酸酸洗液在钢丝热镀锌生产中的应用
2.
Production Practice of High-Carbon Chromium Bearing Steel Wire;
高碳铬轴承钢丝的生产实践
3.
The plating solution selection of Zn-Al-RE alloy for steel wire with hot plating;
锌-铝-稀土合金热镀钢丝助镀剂选择的研究
4) wire
钢丝
1.
On-line Quantitative Inspection of Cracks on Wire by Magnetic Leakage Flux Method;
漏磁场法在线定量检测钢丝裂纹的研究
2.
The present situation of ISO standards about wire rod and wire products and the way how to harmonize our national standards with ISO standards;
盘条和钢丝国际标准现状及我国标准与国际标准接轨的思考
3.
0 mm high strength and low relaxation helix ribbed wire.
0mm高强度、低松弛螺旋肋钢丝是市场的要求。
5) steel wires
钢丝
1.
The point contact hoisting rope was taken as an studied example and a model for the fretting wear of steel wires was developed.
以点接触式提升钢丝绳为研究对象,在实验室建立了钢丝绳中钢丝的微动磨损模型。
2.
Fretting wear and fretting fatigue of steel wires in steel ropes have been identified as a major cause of reducing the life of the rope.
钢丝绳内部钢丝的微动磨损和微动疲劳是造成钢缆寿命降低的主要原因之一 。
6) teel wire
钢丝
1.
o Put forward a feasible way to produce high strength steel wire for rope,recount the adoptive measures combining with practice of the works.
提出了生产高强度制绳钢丝的可行途径，叙述了结合本厂实际所采取的措施。
2.
ontrolling the cooling speed of heated steel wire by using polyacrylic Na aqueous solution as medium can gain convenient morphology for drawing.
用聚丙烯酸钠水溶液作为介质，控制钢丝加热后的冷却速度，可获得利于拉拔的组织。
3.
To introduce the characteristics of heavy coils continuous production line, recount the merits of heavy coils continuous technology in the light of production practice, indicate that such technological process for steel wire production is the most effective and advanced technology at present.
指出这样的钢丝生产工艺流程是目前最有效、最先进的工艺。
参考词条
补充资料：带束层
分子式：
CAS号：
性质：又称支撑层，硬缓冲层，稳定层。指在子午线轮胎和带束斜交轮胎的胎面基部下，沿胎面中心线圆周方向箍紧胎体的材料层。它除了起缓和冲击的作用外，主要起箍紧胎体的作用；对于子午线轮胎来说，它还是主要受力部件。故应采用高强力、高模量和小角度排列的帘线作其增强材料，同时覆以高定伸、高硬度胶料。
CAS号：
性质：又称支撑层，硬缓冲层，稳定层。指在子午线轮胎和带束斜交轮胎的胎面基部下，沿胎面中心线圆周方向箍紧胎体的材料层。它除了起缓和冲击的作用外，主要起箍紧胎体的作用；对于子午线轮胎来说，它还是主要受力部件。故应采用高强力、高模量和小角度排列的帘线作其增强材料，同时覆以高定伸、高硬度胶料。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。