1) numerical control backward table
数控回转台
1.
After the design with studying to the automatic graduation numerical control backward table of his major hardware device is carried out, the range of processing complex ruled surface by WEDM is widened, and the problem in cutting parts with complex surfaces is solved.
开发了能实现空间曲面零件电火花线切割加工的极坐标加工系统,阐明了系统的组成和运动规律,对其主要硬件装置———翻转式自动分度数控回转台进行了设计和研究,从而进一步拓宽了电火花线切割加工的工艺范围,解决了空间曲面零件的加工难题。
2.
Having carried on the design with studying to the automatic graduation numerical control backward table of his major hardware device, thus widen the range of processing complex ruled surface by WEDM, and solved the problem in cutting parts with complex surfaces.
开发了能实现复杂型面零件电火花线切割加工的多轴联动加工系统,阐明了系统的组成和运动规律,研制了其主要硬件装置——数控回转台,并进行了加工实验研究。
2) digital control table
数控回转工作台
3) NC worktable which can be turned
翻转式数控回转台
4) NC rotary table
数控转台
1.
Study on Robust Control for NC Rotary Table Ring Torque Motor Direct Drive Servo System;
数控转台环形力矩电机直接驱动伺服系统的鲁棒控制研究
2.
Study on Fuzzy-Sliding Model Control NC Rotary Table Permanent Magnet Ring Torque Motor Servo System;
数控转台环形力矩电机伺服系统模糊滑模控制的研究
3.
Ring permanent magnet torque motor servo system,used in direct drive NC rotary table,suffers from the effect of load torque change,which greatly reduces the servo dynamic stiffness.
直接驱动数控转台采用环形永磁力矩电机的伺服系统易受负载转矩变化的影响,显著降低系统的伺服动态刚度。
5) two-axis digital control turntable
两轴数控转台
6) rotary NC instruction
回转数控指令
1.
The iterative calculation method for rotary NC instructions was studied in detail.
针对五轴加工中心回转轴运动精度问题,基于多体系统理论,对回转轴运动拓扑结构进行描述,建立数控机床精密加工条件方位约束方程,研究了回转数控指令的迭代修正求解。
补充资料：钢包回转台
ladleturret：设在连铸机浇铸位置上方用于运载钢包过跨和支承钢包进行浇铸的设备。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条