说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 裂缝宽度
1)  crack width
裂缝宽度
1.
Experimental research on crack width of retard-bonded partially prestressed concrete beams with mixed reinforcement;
缓粘结混合配筋预应力混凝土梁裂缝宽度的试验研究
2.
Calculation of the crack width of bending RC member;
钢筋混凝土受弯构件裂缝宽度的计算
3.
Experimental study on crack width of reinforced concrete members with round section;
圆形截面钢筋混凝土构件裂缝宽度试验研究
2)  fracture width
裂缝宽度
1.
The essence of stress sensitivity of fractured reservoir is that the continuously increasing effective stress declines the permeability of reservoir by reducing fracture width.
裂缝性储层应力敏感性本质是有效应力增加不断压缩裂缝空间导致了储层渗流能力减弱,因此,裂缝宽度应力敏感性与渗透率应力敏感性研究同等重要。
2.
On the basis of simplifying well logging interpreting model, formula is derived for determining equivalent fracture width by using dual laterolog data, application conditions for the formula are studied.
并将其结论同裂缝性储层双侧向测井的物理模型和数值模型的模拟响应结果相比较 ,指出了当前国内外普遍使用的计算裂缝宽度的“Sibbit”公式中的一个错
3.
The finite element analysis and experimental means were employed to investigate the influence of pre fracture width on the stress intensifying factors.
通过试验分析和有限元数值计算 ,研究了试件的裂缝宽度对应力强度因子的影响 ,给出了确定无因次应力强度因子与裂尖半径关系的数值方法 ,弥补了解析方法中裂缝零宽度假设的不足。
3)  Width of crack
裂缝宽度
1.
The width of crack and the ratio of reinforcement in concrete structure;
混凝土结构裂缝宽度验算的配筋率控制
2.
Moreover, we got the maximum width of cracks under various loading levels, and obtained the graphs of cracks position.
通过对钢筋混凝土双向密肋楼盖在均布荷载作用下的试验,测出楼盖的实际承载能力、楼盖双向中线的各点挠度及楼盖在各级荷载作用下的最大裂缝宽度,并描出板底裂缝分布图形。
4)  cracking width
裂缝宽度
1.
For the penstocks with inner steel liner and outer reinforced concrete ,their calculating crack widths using existing calculating formulas are compared with the experimental ones which are combined with Three Georges large-sized structure model tests, and we give some opinions for future cracking width.
钢衬钢筋混凝土压力管道应用于大型水电站中,一般在设计时都允许混凝土出现裂缝,但对裂缝宽度进行了限制,而实际工程实测值往往超过计算值。
2.
The formula is developed for the calculation of the cracking width and suggestions are put forward for calculating the average width of cracking.
对静载作用下的高强钢筋混凝土梁进行试验研究,提出了平均裂缝间距以及裂缝宽度计算公式的改进建议。
3.
The paper also develops the formulae for the calculation of the cracking width,and suggests how to calculate the average distance of cracking.
对静载作用下的高强钢筋混凝土梁与普通钢筋混凝土梁进行了对比试验研究,验证了高强钢筋混凝土梁能够更好满足正常使用极限状态要求,并将高强钢筋混凝土最大裂缝宽度计算公式进行改进,对平均裂缝间距计算提出了新的建议。
5)  width of cracks
裂缝宽度
1.
The experimental results show that the rehabilitation can effectively reduce the width of cracks and make the cracking time advancing.
结果表明,采用该材料加固梁,可有效降低梁裂缝宽度,并延迟裂缝的出现。
6)  diagonal crack width
斜裂缝宽度
1.
However, 500MPa (Ⅳ) steel bar as anti-cut the stirrup research just to start, it possibly appear the diagonal crack width which can not to be able to satisfy the s.
本文通过对8根500MPa箍筋混凝土T形截面梁的试验,分析了500MPa钢筋混凝土梁在均布荷载作用下斜裂缝产生和发展过程及开裂模式,并在此基础上重点讨论了不同的影响因素,即混凝土强度、钢筋强度、配箍率对试验梁的开裂、裂缝宽度的影响,讨论了试验梁在使用荷载阶段能否满足最大斜裂缝宽度限值的要求。
2.
The effect of loading form,concrete strength,section shape and stirrup ratio on diagonal crack width was analyzed.
对20根配有500 MPa钢筋作为抗剪箍筋的混凝土梁进行试验,分析加载方式、混凝土强度、截面形式以及配箍率对混凝土梁斜裂缝宽度的影响。
3.
Twelve reinforced concrete(RC) beams with 500 MPa steel bars as the stirrups were tested to investigate the shear behavior respectively under concentrated and uniformly-distributed loads,and the shear capacity of the diagonal section and the diagonal crack width of the beams in the service stage were analyzed.
为了研究以500MPa钢筋为箍筋的混凝土梁在集中荷载和均布荷载下的受剪性能,对12根混凝土梁进行了试验研究,分析了高强箍筋混凝土梁的斜截面受剪承载力及其在使用阶段的斜裂缝宽度
补充资料:大型设备基础混凝土裂缝防治


大型设备基础混凝土裂缝防治
protection and treatment for crack during construction of large volume foundation

  daxlng shebe一Jiehu hunningtu}iefeng fangZhl大型设备蓦础混凝土裂缝防治(proteetion。ndtreatment for eraek during eonstruetion of large vol-ume foundation)在冶金工厂建设中,设备基础的混凝土约占混凝土工程总量的60%以上。随着冶金设备向大型化发展,设备基础的体积愈趋庞大。以中国上海宝钢工程为例,容积为4063m“的1号高炉,其基础混凝土工程量约为600om3;3座3oot转炉的基础底板的混凝土工程量将近700om“。施工时每次混凝土的浇筑量多在looom3以上。施工中,水泥水化热引起混凝土浇筑块体内部温度和温度应力剧烈变化,以及混凝土的凝结收缩,都会引起对结构整体性、耐久性和强度有影响的混凝土裂缝。防止这种裂缝的产生和对已出现裂缝的有效治理是保证工程质量的关键之一。 裂缝原因和防止原则在大型设备基础的施工中,当混凝土内部温度变化和凝结收缩引起的变形受到约束时,浇筑块体内就要产生应力。当其中的拉应力超过混凝土材料的抗拉极限时就会出现裂缝。对变形的约束有两类情况:一是混凝土浇筑块体内部各质点间因变形量不同而产生相互牵制和影响,称为“自约束”;二是浇筑块体的变形受到外部物体(如地基、相邻结构、下部混凝土浇筑层等)的阻碍,称为“外约束”。 为防止裂缝的产生,应从以下几个方面考虑对策。(1)提高混凝土自身和混凝土结构的抗裂能力。施工中要严格控制材料和施工工艺,使结构质量完全符合设计和规范要求。(2)减少混凝土中的总发热量,降低水泥水化发热速率,合理调剂混凝土在凝结过程中的温度与湿度,以减小温度应力和收缩产生的应力。(3)减弱内、外约束的影响。(4)重视控制温度对防止裂缝产生的决定性作用,在基础施工的全过程中,按阶段进行温度应力分析,确定温度控制指标和技术措施。 沮控防裂措施包括基础设计、混凝土配制、混凝土浇筑与养护、施工中混凝土温度监测四个方面。 基础设计主要措施有:(1)基础混凝土的强度等级应为C巧一C25。(2)对独立的大型钢筋混凝土设备基础不设沉降缝、温度缝等永久变形缝。(3)当基础设置于岩石地基上时,在混凝土垫层上表面应设滑动层(可采用一毡二油构造),以减少地基对混凝土变形的约束。(4)基础配筋除应满足基础承载力及构造要求外,还要增配承受因水泥水化热引起的温度应力及控制裂缝开展的构造钢筋。 混凝土配制主要措施有:(1)选定混凝土配合比时,应在保证基础强度、耐久性和施工工艺要求的前提下尽量减少水泥用量,以降低混凝土的绝对温升值。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条