1) corrosion of 1Cr13 stainless steel
1Cr13不锈钢的腐蚀
1.
The effects of Sulfate Reducing Bacteria (SRB) on corrosion of 1Cr13 stainless steel in the soils of different Cl-content have been investigated.
结果表明:随着土壤中Cl~-含量的增大,1Cr13不锈钢的腐蚀速率和最大点蚀深度随着土壤中Cl~-含量的增加而增大,当Cl~-的含量增大到1。
2) 1Cr13 stainless steel
1Cr13不锈钢
1.
Vacuum brazing between TiC/NiCr cermets and 1Cr13 stainless steel;
TiC/NiCr金属陶瓷与1Cr13不锈钢的真空钎焊
2.
Titanium coating had been deposited on 1Cr13 stainless steel substrate using cold spray technique.
0MPa,载气温度为500℃的状态下,用冷喷涂的方法在1Cr13不锈钢基体上制备了钛金属涂层。
3.
TiC/Ti(C, N)/TiN multi-layer coatings are prepared on the 1Cr13 stainless steel substrate by the technique of Chemical Vapour Deposition, and the fretting wear behaviour of 1Cr13 stainless steel and TiC/Ti(C, N)/TiN coatings are investigated and studied contrastively from 25℃ to 400℃ in the gross slip regime.
采用化学气相沉积(CVD)技术,在1Cr13不锈钢基体上制备TiC/Ti(C,N)/TiN复合涂层。
3) Cr13 stainless steel
1Cr13不锈钢
1.
Corrosion test methods, such as bacterial analyses, weight loss, electrochemical impedance spectroscopy, scanning electron microscopy (SEM) and EDXA, were used to study the effects of sulfate reducing bacterial (SRB) on corrosion of 1Cr13 stainless steel in sea mud and the corrosion of the steel in the macrocell composed of sea muds with and without SRB.
利用交流阻抗测试技术 ,扫描电镜及表面能谱、失重法、微生物分析等方法 ,在室内模拟条件下研究了海泥中硫酸盐还原菌对 1Cr13不锈钢腐蚀的影响 ,及在含和不含硫酸盐还原菌的海泥构成的宏电池腐蚀中 1Cr13不锈钢的腐蚀行为。
2.
The corrosion behavior of 1Cr13 stainless steel in soils were studied.
通过在酸性、中性及碱性土壤中埋设试件的方法,研究了1Cr13不锈钢分别经过1年、3年、5年这三种试验周期后的腐蚀行为特征。
4) corrosion of stainless steel
不锈钢腐蚀
1.
The recent advances in research of the relationship between the chloride ion and the corrosion of stainless steel in cooling water system are reviewed.
综述了有关氯离子对冷却水系统中不锈钢腐蚀研究的最新进展,涉及冷却水中氯离子引发不锈钢孔蚀、缝隙腐蚀和应力腐蚀开裂的机理,氯离子的限度,以及影响水中不锈钢腐蚀的其他因素。
5) REVIEW ON ATMOSPHERIC CORROSION OF STAINLESS STEELS
不锈钢的大气腐蚀
6) stainless steel grain-boundary corrosion
不锈钢晶间腐蚀
1.
Using electrochemical reactivation method study and survey stainless steel grain-boundary corrosion sensitivity;compare the present result with the past one in traditional way -Using electrochemical reactivation method to survey stainless steel especially to survey the sensiticoty in stainless steel compositeplate grain-boundary conrosion is an accurate,rapid and ideal checking method.
用电化学再活化法研究测量了不锈钢晶间腐蚀敏感性的大小 ,并与传统方法的测量结果做了比较。
补充资料：Ti-13V-11Cr-3A1 alloy
分子式：
CAS号：
性质：β钛合金。成分为钒13％，铬11％，铝3％，余量钛。退火后室温机械性能：抗拉强度862MPa，屈服强度827MPa，延伸率10％，弹性模量10.34×104MPa，HRC硬度32～36。采用真空自耗电弧炉熔炼制取。制造紧固件和较大面积的模锻件。
CAS号：
性质：β钛合金。成分为钒13％，铬11％，铝3％，余量钛。退火后室温机械性能：抗拉强度862MPa，屈服强度827MPa，延伸率10％，弹性模量10.34×104MPa，HRC硬度32～36。采用真空自耗电弧炉熔炼制取。制造紧固件和较大面积的模锻件。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条