1) pyramidal indenter
锥形压头
1.
Combining the recently published hardness results for spherical indenter case and the Johnson's correlation for metal materials, the hardness solution form of elastic-plastic materials for the pyramidal indenter case about which a small curvature radius at tip is considered is derived.
结合近来发表的对金属材料采用球形压头的微压痕实验结果及Johnson对应原理,讨论了在传统弹塑性理论下锥形压头在计及压头顶端曲率半径影响时硬度的解答形式,进而得出结论:压头尖端曲率半径不是引起尺度效应的根源,相反,它会使尺度效应减弱。
2) tapered end
锥形头，锥形接头
3) Conical Head
锥形封头
1.
Study on feasibility of conical head with half top angle>60°;
半顶角大于60°锥形封头的可行性研究
2.
In this paper, two problems-the design of conical heads subjected to external pressure and stress intensity existing around opening are analyzed and discussed.
本文对外压锥形封头设计以及开孔接管处的应力强度等两个问题进行分析。
3.
In this paper,the authors carried out stress analysis for knuckle (transitional section) of toriconical heads (conical heads with transitional section),proposed another rule design method based on membrane theory,which is contrasted with the rule design method in operation,for the knuckle of toriconical heads.
对折边锥形封头的过渡段部分进行应力分析，提出以无矩理论为基础的常规设计方法，并与现行常规设计方法（国家标准ＧＢ１５０—８９《钢制压力容器》所规定的方法）进行比较，同时研究了计算厚度公式。
4) cone nozzles
锥形喷头
5) conical connecting
锥形接头
6) taper bit
锥形钻头
补充资料：无弹性架压磁测力传感器压头
无弹性架压磁测力传感器压头
无弹性架压碰测力传感器压头
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条