1) phosphate rock sintering
磷矿烧结
1.
The reason why recycles occur during phosphate rock sintering is analyzed, and the influence of recycles on the process is stated.
分析磷矿烧结中返料产生的原因 ,结合生产简述返料对烧结过程的影响 ,指出俄罗斯原设计中的问题 ,提出降低返料提高成品率的重点应放在降低一次返料量上。
2.
Based on the production and analysis on phosphate rock sintering, some view points are stated that ignition directly produces an impact on vertical sintering rate, heat preservation time should be prolonged and oxygen in flue gas be increased.
结合云南磷肥工业公司磷矿烧结生产 ,分析磷矿烧结点火的特点 ,指出所存在的保温时间短和烟气含氧量不足的问题 ,提出 4点改进点火的方
2) technology of sintering ground phosphate rock
粉状磷矿的烧结技术
1.
Creativity and circulation economy-the only developing way of phosphorous chemical industry:Ⅰ.the integrated utilization of tail gas from yellow phosphor production and the technology of sintering ground phosphate rock;
创新和循环经济是磷化工发展的必由之路:Ⅰ.黄磷尾气的综合利用与粉状磷矿的烧结技术
3) sinter
[英]['sintə] [美]['sɪntɚ]
烧结矿
1.
Effects of MAC fines proportion on sinter properties at Han Steel;
MAC粉配比对邯钢烧结矿性能的影响
2.
Study on the improvement of sinter strength;
提高烧结矿强度的试验研究
3.
Study on lowering Reduction Degradation Index(RDI) of sinter;
降低烧结矿低温还原粉化率的试验研究
4) sintered ore
烧结矿
1.
Production practice on reduction of sintered ore content in grain size ≤10mm;
降低烧结矿≤10mm粒级率的生产实践
2.
Determination of irom? in sintered ore by the combined analyzer of X-ray fluorescence and X-ray diffraction;
结合式XRF-XRD光谱仪测定烧结矿中FeⅡ
3.
Combination forecasting of sintered ore alkalinity based on grey neural network;
基于灰色神经网络的烧结矿碱度组合预测
5) ore sintering
矿石烧结
1.
The ore sintering is an important part in ironmaking process.
矿石烧结是炼铁工艺流程的重要组成部分,烧结矿的质量直接影响高炉的炉况及铁水质量,而影响烧结矿质量关键的因素是终点温度和透气性。
6) Sinter ore
烧结矿
1.
Evaluation of uncertainty for determination of TFe in sinter ore by XRF;
X射线荧光光谱法测定烧结矿中TFe的不确定度评定
2.
Development and application of sinter ore control-sample were researched.
本文对烧结矿控样的研制与应用进行了深入的研究,提出了可行的分析方法,为拓展仪器分析提供了依据。
3.
in sinter ore and the standardized grinding method and double grinding to control the grain size during the sampling,X-ray fluorescence strength of sample is measured and the content is calculated by software.
通过X射线荧光光谱粉末压片法分析烧结矿中的TFe、SiO2、CaO、MgO、Al2O3等成分的含量,在制样过程中采用标准化研磨方法和二级筛分控制样品的粒度,在光谱仪上测量样品的X射线荧光强度。
补充资料：带式烧结机在出矿(鞍钢)
带式烧结机在出矿(鞍钢)
带式烧结机在出矿(鞍钢)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条