说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 最佳粘度
1)  optimum viscosity
最佳粘度
2)  optimal temperature
最佳温度
1.
A mathematical model of expressing the relatinnship between the optimal temperature (Tm) and the height of the catalyst bed(L ), the optimal CO conversion ratio (xCO,m)or the optimal CO composition (yco,m) and the height of the catalyst bed (L ) has been established.
建立了一氧化碳变换反应催化剂床层中最佳温度(Tm)与床层高度(L)、最佳一氧化碳转化率(xco,m)或最佳一氧化碳浓度(yco,m)与床层高度(L)关系的数学模型,绘制了Tm-L、xco,m-L和yco。
3)  the best concentration
最佳浓度
1.
The article discussed influences that common-ion effect and Complex effect act on deposition solubility on gravimetry,and deduced the calculating formula of controlling the best concentration of precipitator to make precipitation complete during the concurrence of the mentioned two effects.
对重量分析中既存在同离子效应又存在络合效应时沉淀剂对沉淀溶解度的影响进行了探讨,并推导出两种效应同时存在时要使沉淀反应完全,应控制沉淀剂最佳浓度的计算公式。
2.
According to teaching practice of weight analysis of analysis chemistry,the influences that identical ionic effect and coordination effect on deposition solubility were discussed,and the calculating formula for the best concentration of precipitator to make precipitation complete was deduced in the article.
根据分析化学理论课重量分析一章的教学实践,讨论同离子效应和配位效应同时存在时对沉淀溶解度的影响,推导出要使沉淀反应完全,沉淀剂最佳浓度的计算公式。
4)  optimum temperature
最佳温度
1.
The effect of Fe_2O_3 on medium temperature FGD characterization,optimum temperature in fixed bed and proportion of Fe_2O_3 and CaO were studied in the experiment.
研究了加入氧化铁添加剂后,对中温烟气脱硫性能的影响和对固定床干法脱硫最佳温度的影响,氧化铁配比对氧化钙脱硫性能的影响等。
2.
The optimum acidity and optimum temperature of cellulose degradation by cellulase were obtained.
用微量热法测定了不同酸度和不同温度下纤维素酶降解纤维素的热功率—时间曲线,应用热动力学理论和对比进度法解析出反应的米氏常数(Km)和最大速率(Vmax),并得出速率常数k2,建立速率常数与酸度和温度间的关系式,从而获得纤维素酶降解纤维素的最佳酸度和最佳温度。
3.
The optimal mathematical models on the axial optimum temperature and maximum synthetic rate for a continuous heat exchange ammonia converter were established.
建立了连续换热式氨合成塔轴向最佳温度和最大合成率的优化模型,采用牛顿迭代法和龙格-库塔法对模型进行了数值解。
5)  optimum acidity
最佳酸度
1.
The optimum acidity and optimum temperature of cellulose degradation by cellulase were obtained.
用微量热法测定了不同酸度和不同温度下纤维素酶降解纤维素的热功率—时间曲线,应用热动力学理论和对比进度法解析出反应的米氏常数(Km)和最大速率(Vmax),并得出速率常数k2,建立速率常数与酸度和温度间的关系式,从而获得纤维素酶降解纤维素的最佳酸度和最佳温度。
2.
The optimum acidity(pH=5.
利用微量量热仪,研究了酸度,温度及金属离子对酶催化反应的影响,测出内切葡聚糖酶催化反应的热功率-时间曲线,根据曲线上的数据,按照热动力学理论和对比进度法解析出不同条件下酶催化反应的最大反应速率(Vmax)和米氏常数(Km),从而得到酶解的最佳酸度(pH=5。
6)  optimal thickness
最佳厚度
1.
Finite element analysis on optimal thickness of single layered coating;
单层涂层最佳厚度的有限元分析
2.
Therefore,it is necessary to study the optimal thickness of asphalt overlay.
综合力学分析和试验路观测结果 ,给出了复合路面沥青罩面层的最佳厚度 ,为工程应用提供参
补充资料:硫酸粘菌素 ,粘菌素,硫酸多粘菌素E
药物名称:多粘菌素E

英文名:Polymyxin E

别名: 多粘菌素E;可立斯丁;可刹迈仙干糖浆;硫酸抗敌素;硫酸粘菌素 ,粘菌素,硫酸多粘菌素E
外文名:Colistin ,Polymyxin E
性状:
常用其硫酸盐,为白色或微黄色粉末;无臭或几乎无臭。有引湿性。在水中易溶,在乙醇中微溶,在丙酮、氯仿或乙醚中几乎不溶。
药理作用:
抗菌谱和体内过程与多粘菌素B相同。口服不吸收,用于治疗大肠杆菌性肠炎和对其它药物耐药的菌痢。外用于烧伤和外伤引起的绿脓杆菌局部感染和耳、眼等部位敏感菌感染。注射已少用。
适应症:
用于治疗大肠杆菌性肠炎和对其他药物耐药的菌痢。外用于烧伤和外伤引起的绿脓杆菌局部感染和耳、眼等部位敏感菌感染。注射已少用。
用量用法:
1.口服:成人1次50万~100万单位,1日3~4次。儿童1次量25万~50万单位,1日3~4次。重症时上述剂量可加倍。 2.外用:溶液剂每毫升含1万~5万单位,氯化钠注射液溶解。
注意事项:
1.可发生皮疹、瘙痒等过敏症状。胃肠道有恶心、呕吐、食欲不振、腹泻等不良反应。 2.孕妇慎用。 3.口服宜空腹给药。
规格: 片剂:每片50万;100万;300万单位。灭菌粉剂:每瓶100万单位,供制备溶液用(1mg=6500单位)


类别:抗生素
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条