Comparative analysis of mechanism of four levered slay blowing for air jet looms ZA200 regarding acceleration,minimum transit angle,wefting condition and open motion of short traverse slay blowing and typical slay blowing.

Application of XML in CNC automatic programming system;

Automatic Programming of EDM Engraving;

Prestack depth migration by wave equation-based focus-point controlled illumination;

Forward simulation of ground penetrating radar and its finite difference method wave equation migration processing;

3-D forward modeling of wave equation using explicit short operator;

Oxidation resistant coating technology applied to steel billet in high temperature dynamic process;

Simulation of dynamic process of nonline simulated moving bed chromatography;

Fouling and slagging dynamic processes in boiler with electron probe microanalyzer;

Effect of different pretreatments on electrokinetic processes of electroplating sludge;

Investigation on the starting process of the direct impulse combustion wind tunnel

The result showed that the conveyor has big design parameter,appropriate starting velocity,little dynamic belt tension change and steady starting process.

During the research of 11kW rare earth permanent magnet brushless DC motor starting process,the control strategy by slope voltage was used to reduce the higher current.