1) conventional oil quenching
普通空气加热油淬
1.
W18Cr4V steel was heat-treated by vacuum gas quenching and conventional oil quenching respectively.
采用真空气淬法和普通空气加热油淬法分别对W18Cr4V钢进行热处理。
3) conventional quenching oil
普通淬火油
4) conventional heating
普通加热
1.
Nanosized zeolite T with the mean size range of 80～150 nm was synthesized by conventional heating or microwave heating at 85 ℃ with the addition of 10% template.
在85℃和添加质量分数为10%模板剂的条件下,采用普通加热或微波加热方法合成了平均粒径在80~150 nm范围的T型分子筛。
2.
Compared with the conventional heating method, not only was crystallization time reduced over 80%, but also the crystallinity and surface area of crystals were improved.
T型分子筛的合成研究较少[5￣11],制备过程均采用普通加热(ConventionalH eating,CH)法。
5) fuel-fired air heater
燃油空气加热器
1.
Research on emission control of vehicle fuel-fired air heater;
汽车燃油空气加热器燃烧排放控制研究
2.
Noise property of vehicle fuel-fired air heater;
汽车燃油空气加热器噪声性能
6) oil fired heater
烧油空气加热器
补充资料：双室油淬加压气淬真空炉ZYC_2-65
双室油淬加压气淬真空炉ZYC_2-65
双室油淬加压气淬真空炉zY02—65
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条