2) experimental design
试验设计法
1.
According to the problems occuring in a certain part of the military products, this paper finds out the best combination successfully by using the experimental design, which increases the strength of this part and make the production proceed smoothly.
根据某军品部件出现的问题,应用试验设计法成功地找出了最优组合,提高了该部件的强度,解决了该强度问题,使生产得以正常进行。
3) SN-ratio experimental design
SN比试验设计法
1.
Based on SN-ratio experimental design, This paper analyzes the law of every factor's effect on surface roughness of grinding and looks for the best grinding condition with which can be obtained the minimum surface roughness.
通过SN比试验设计法,就各因素对磨削表面粗糙度的影响规律加以分析,并寻求能够获得最小表面粗糙度的最佳加工条件,同时提出预测表面粗糙度的方法,并通过实验加以验证。
4) well-distributed design
均匀设计试验法
1.
The well-distributed design was used to study the effect of extraction alkaloids in sophora alopecuroides L.
采用均匀设计试验法考察浸提时间、溶剂浓度、料液比、浸提温度及苦豆籽粉粒度对苦参碱浸出率的影响,确定出最佳提取方案为原料粒度16目、乙醇浓度为85%、浸提温度50℃、提取时间5h,苦参碱提取率可达75%。
5) Orthogonal Design
正交设计试验法
1.
Studies on a High Sensitivity Reaction of Vanadium (Ⅴ) with Diantipyryl-(o-Ethoxy)-Phenylmethane (DAoEM) by Orthogonal Design;
正交设计试验法研究二安替比林邻乙氧基苯基甲烷与钒(Ⅴ)的高灵敏显色反应
6) orthogonal experiment
正交试验设计法
1.
The orthogonal experiment is used in Xinlin Sewage Water Treatment Plant.
采用正交试验设计法在厦门杏林污水处理厂进行试验 ,通过极差分析和方差分析确定污泥负荷和污泥龄是活性污泥法去除污水中有机污染物和磷的显著影响因素 ;其最佳操作条件为HRT =5h ,F/M>0 0 5kg (BOD5 ) /kg (MLSS) ;SRT =2 3-4 0d ,可生化比 >4 5,温度 =1 5-33℃。
2.
The orthogonal experiment was used in studying the process performance and membrane fouling during isoelectric supernate of monosodium glutamate was treated by bipolar membrane electrodialysis.
采用正交试验设计法研究双极膜电渗析处理味精等电母液时的过程性能和膜污染,连续5批试验,考察了操作电流、流速、温度和酸室初始浓度对电渗析性能(硫酸根的平均再生率、能耗总和)和膜污染(膜湿重及能耗增加量)的影响。
补充资料：焦化试验室设计(见焦化厂试验室设计)
焦化试验室设计(见焦化厂试验室设计)
design of coking laboratory
J一aohua shiyanshi sheji焦化试验室设计(design of。oking laborato-ry)见焦化厂试验室设计。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条