1) charge/discharge
充电/放电
1.
The "charge/discharge" roles of the basin-wide mode of the Indian Ocean SST anomaly——influence on the South Asian High in summer;
热带印度洋SST海盆模态的“充电/放电”作用——对夏季南亚高压的影响
2) charge-discharge
充放电
1.
The charge-discharge cycles showed that Ti-doped sample prepared at 600℃,spinels without doping sintered at 600 and 750℃,exhibited a initial capacity of 205,189 and 207mAh/g in the 1st 40-cycles,respectively.
充放电实验表明,在4。
2.
Screening battery from its charge-discharge characteristics is an unique trait peculiar to this system.
采用三级计算机控制方式、多功能电池夹具和模块化结构研制的二次电池检测系统,具有功能多、性能稳定和实用性强的特点,还独创了按充放电性能曲线分选电池的功能。
3.
During the charge-discharge cycles of amorphous (Mg_(60) Ni_(25))_(90)Nd_(10) alloy,NdMg_2 Ni_9 phase appears after four cycles and Mg_2 Ni phase appears after six cycles.
5) Nd_(10)在充放电循环中的组织演变。
3) charge and discharge
充放电
1.
New-type photovoltaic charge and discharge controller;
一种新型光伏发电充放电控制器
2.
Research of Li-ion Charge and Discharge System;
大功率锂离子蓄电池充放电系统的研究
3.
Investigation of Charge and Discharge for Battery Based on Techniques of Bidirectional Converter;
基于双向变流器技术的蓄电池充放电装置的研究
4) charging and discharging
充放电
1.
Analysised charging and discharging of lead-acetate battery;
浅析铅酸蓄电池的充放电过程
2.
Ship lead-acid battery charging and discharging;
船舶铅酸蓄电池与充放电
3.
The host computer is PC which can watch on the whole process of charging and discharging,data controlling,collecting and saving,and real-time displaying the wave form of every cell,and analyzing the data and output it as diagram etc.
该系统分为上位机和下位机2部分,上位机为普通PC机,可完成对电池充放电过程全面监测及数据采集的监控、存储,实时显示各只电池充放电波形,及时分析数据并以图表方式输出等;下位机由单片机结合CPLD构成主控单元完成电池充放电状态切换、电压电流数据的上传等功能。
5) charge/discharge
充放电
1.
The principle and charge/discharge characteristic of Lithium-ion battery are discussed.
针对锂离子电池带来的安全问题,讨论了锂离子电池的工作原理、充放电特性。
2.
Results show that the charge/discharge capacity decrease with increasing of the doping compositions,however charge/discharge efficiency and cyclic properties increase.
用溶胶-凝胶法制备了不同量铜掺杂尖晶石锂锰氧化物,并用扫描电镜、恒电流充放电、循环伏安等方法研究了制备样品的性能。
3.
This thesis researches hardware and arithmetic software scheme of an embedded controller system, which can control four charge/discharge devices and operate in distributed architecture.
化成充放电是蓄电池生产的关键工艺之一，其控制过程直接关系到产品的质量。
6) charge and discharge capacit
充放电量
补充资料：充电
分子式：
CAS号：
性质：蓄电池从外电路接受电能，转化为电池的化学能的工作过程。蓄电池在其能量经放电消耗后，通过充电恢复，又能重新放电，构成充放循环。一般用直流电流(也有用不对称交流电流或脉冲电流)充电。不同情况下，采用不同的充电方法如恒流充电、恒电压充电、浮充电、涓流充电、急充电或这些方法的组合式充电等。
CAS号：
性质：蓄电池从外电路接受电能，转化为电池的化学能的工作过程。蓄电池在其能量经放电消耗后，通过充电恢复，又能重新放电，构成充放循环。一般用直流电流(也有用不对称交流电流或脉冲电流)充电。不同情况下，采用不同的充电方法如恒流充电、恒电压充电、浮充电、涓流充电、急充电或这些方法的组合式充电等。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条