1) axial backmixing parameter
轴向返混参数
1.
The results shown that the axial backmixing parameter Pe increases with increasing opening ratio and the inclination angle β and with decreasing the unit height of the packing H and that the pressure drop of packing layer Δ p/Z decreased with increasing opening ratio and unit heig.
研究结果表明 ,轴向返混参数随开孔率、倾角的增加及盘高的减小而增加 ,填料层压降随开孔率、盘高的增加及倾角的减小而降低 ,传质单元高度随倾角的增加、盘高的减小而降低 ,开孔率对传质单元高度的影响有一个适宜值 。
2) axial backmixing parameter P_e
轴向返混参数Pe
3) axial backmixing coefficient
轴向返混系数
4) axial dispersion
轴向返混
1.
The experimental results show that the axial dispersion in the column packed with 250Y or 350Y structured packings is the least while.
通过比较发现,在所用填料中,装有250Y或350Y型填料的浮选柱不仅轴向返混最小,而且径向返混最大,最有利于提高回收率。
2.
The model parameters had been measured with stimulate_response method and axial dispersion coefficients were estimated with transfer function and Fourier analysis method.
结果表明 ,不同柱高、柱径和流速下由两种方法计算得到的轴向返混系数数值相当 ,这也验证了此二法的准确性 。
3.
The axial dispersion coefficients and total mass transfer coefficients of xylose and sorbinose have been determined by stimulate response,technique with intert substance being traced.
用惰性物质为示踪剂，采用扰动－应答技术测定了固定床的轴向返混系数与传质系数。
5) axial back mixing between stages
级间轴向返混
6) radial dispersion
径向返混
1.
An experimental study on axial and radial dispersion of liquid was carried out in a 0.
以二维扩散模型为基础,采用点源脉冲示踪法对开式浮选柱和装有不同类型规整填料的充填式浮选柱内液相的轴向与径向返混进行了实验研究,得到了各种填料内轴向和径向彼克列准数与气相、液相表观雷诺数的关联式。
补充资料：返轴
1.指回车。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条