说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 压缩量
1)  Amount of compression
压缩量
1.
Calculation of initial amount of compression of tubing is an important parameter for calculation analysis of one packer string force.
初始油管压缩量计算 ,是某些封隔器管柱受力分析计算的重要参数 ,它不仅能够对封隔器坐封时现场施工提供指导 ,而且还是后续施工或完井过程中计算管柱的受力和变形的基础。
2.
To make use of FWD to evaluate its structure,adopting the elastic layer system(BISAR) to establish the structural model,the amount of compression for asphalt concrete overlay from the aspects of entire design parameters and the different contact conditions between different layers is detailedly studied.
为能够利用FWD对其进行结构评价,采用弹性层状分析程序(BISAR)建立结构模型,从整个设计参数范围、不同层间状态出发,对沥青混凝土层压缩量进行系统研究。
2)  compressive modulus
压缩模量
1.
Calculation of compressive modulus of grid structure -composite foundation;
格栅状复合地基压缩模量的计算
2.
Value determination problem of compressive modulus E_s of soil layers ⑦,⑧ and ⑨ in Shanghai soft soil foundation;
论上海软土地基⑦⑧⑨层压缩模量E_s的定值问题
3.
It was found that gelatin coatings were formed on the pore walls of porous scaffold samples successfully without destroying their porous characteristic,but these coatings improved the compressive strength and compressive modulus o.
复合明胶涂层提高了样品的压缩强度和压缩模量,与未涂覆样品相比,涂敷样品受压时的应变特性发生了明显变化。
3)  compression modulus
压缩模量
1.
Test research on compression modulus of sandy soil tunnel surrounding rock;
砂类土体隧道围岩压缩模量的试验研究
2.
The response to electric field of the composite systems was studied by measure of compression modulus of the elastomers and dynamic-exam of resistance in the cure .
通过对弹性胶体压缩模量的测试和胶凝过程中电阻的动态监测,研究了胶体体系对电场的响应行为。
4)  compressibility modulus
压缩模量
1.
The compressibility modulus of the dewatering subsidence,sE,is mainly determined by the character diameter of the sand,20D,and the ef.
疏水沉降的侧限压缩模量sE受特征粒径20D和水压降hD控制,20D,hD越大,sE越大;当土样不变时,sE与hD呈正相关关系;当hD一定时,土体的细颗粒含量越多,20D越小,则侧限压缩模量sE越小,土体变形量越大。
2.
Based on settlement data measured in field,compressibility modulus and consolidation coefficient of soil layers are obtained by back analysis method.
基于沉降实测资料,采用反分析方法,确定了各土层的压缩模量和固结系数,并将反演得到的参数代入太沙基一维固结方程,对后续沉降进行预测,从而确定分级压载的下一级压载时间与压载量。
5)  modulus of compressibility
压缩模量
1.
Discussion on formula of modulus of compressibility of soil;
土压缩模量计算公式的探讨
2.
Discussion of modulus of compressibility due to sea level rise in Shanghai region;
未来上海地区海平面上升对土压缩模量的影响分析
6)  modulus of compression
压缩模量
1.
Discussion on modulus of compression formula;
关于压缩模量公式的探讨
2.
Based on the data of the geotechnical engineering exploration in Panyu, Guangzhou, This paper discusses the linear relevant relations between blowcount of standard penetration test and modulus of compression in the alluviation clay of powder quality according to variance analysis, and then inspects this linear model.
利用广州市番禺区某工程地质勘察数据,运用回归分析方法探讨冲积粉质粘土层标准贯入击数与压缩模量间的线性关系,并对推导出的线性模型进行检验,对工程地质勘察工作有一定的实用价值。
补充资料:压缩机排气量
分子式:
CAS号:

性质:又称压缩机排气量。压缩机单位时间内在标准排气位置上测得的实际容积流量换算到标准吸气位置上在全温度、全压力及其湿度条件下的气体体积量。换算时还应顾及可压缩性误差、中间有无水分(或液体)析出以及化工流程中洗涤掉或添加进的气体容积。它表征压缩机的大小,但并不表明压缩机所排气体的物质数量。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条