1) pre?crosslinked gel
预交联凝胶微粒
1.
Depth profile control technology of pre?crosslinked gel particles is that polymer crosslinked system formed gel by crosslinking at ground, then gel particles have prepared through the processes of granulation, drying, flouring, screening and so on, at last depth profile control in water injector is carried out.
预交联凝胶微粒深度调剖技术是将聚合物交联体系在地面交联形成凝胶 ,然后经造粒、烘干、粉碎、筛分等工艺过程制备成凝胶微粒 ,进行注水井深度调剖。
2) pre-crosslinked gel particle
预交联凝胶颗粒
1.
This article investigates the behavior of pre-crosslinked gel particles in sealing fractured and low-permeability oil reservoir,inspects the relationship between particle intensity,toughness,size and fracture width,and the impact of pellet aerosol and viscoelasticity on the seal-off behavior through fractured core flow test.
定性研究了预交联凝胶颗粒对裂缝性低渗透油藏的封堵性能。
3) preformed particle gel
预交联聚合物凝胶颗粒
1.
The results showed that with the swelling time being longer,the viscosity and elasticity of the preformed particle gel dispersion system became higher.
采用HAAKE RS600型流变仪、膜过滤实验及激光粒度仪和光学显微镜,研究了预交联聚合物凝胶颗粒分散体系的流变性能、封堵性能和颗粒的形态、大小。
4) precrosslinked gel
预交联凝胶
1.
The SPs used are a commercial particulated precrosslinked gel,HLP-02,of particle size 200 mesh and of swelling factor 80—90 in common fresh water in 24 hrs and are prepared in 5 g/L suspension in simulation formation water of TSD=120 g/L.
所用体膨剂为工业品,代号HLP-02,为一种预交联凝胶颗粒,平均粒度200目,在自来水中24小时膨胀倍数80~90,在矿化度120 g/L的模拟地层水中配成5g/L的悬浮液。
5) hydrogel particles
凝胶微粒
1.
The core shell hydrogel particles are prepared with a two step method.
简要综述了感温型凝胶微粒的微观结构 ,及其制备方法和影响其膨胀 -收缩性能的主要因素等方面的研究进展。
6) micro gel
微粒凝胶
补充资料：Sds-聚丙烯酰胺凝胶电泳凝胶电泳
sds-聚丙烯酰胺凝胶电泳（sds-page，sodium dodecyl sulfate-polyacrylamide gel electrohoresis）
在有去污剂十二烷基硫酸钠存在下的聚丙烯酰胺凝胶电泳。sds-page只是按照分子大小分离的，而不是根据分子所带的电荷和大小分离的。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条