说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 迟滞特性
1)  hysteresis [英][,histə'ri:sis]  [美][,hɪstə'risɪs]
迟滞特性
1.
Mechanism analysis of sidegating effect hysteresis in GaAs MESFETs
GaAs MESFET旁栅迟滞特性的机理分析
2.
To reduce the effect of hysteresis of piezoceramic actuator to the accuracy of the nano positioning stage,inverse Preisach model is used to compensate the hysteresis nonlinearity and an adaptive sliding mode controller is designed to cancel the remaining hysteresis,uncertainty of the model,and other disturbances.
为了降低压电陶瓷执行器迟滞特性对纳米定位平台精度的影响,利用Preisach逆模型补偿迟滞特性,并针对逆模型未能完全补偿的迟滞特性、模型参数的不确定性以及其他扰动设计了自适应滑模控制律。
3.
To improve the modeling accuracy,this paper presented an average hysteresis model as compensation of the CPM.
压电陶瓷执行器物理结构复杂,通过参数化方法辨识经典Preisach模型(CPM)描述其迟滞特性时,难以找到合适的Preisach函数,模型预测误差较大。
2)  hysteresis characteristic
迟滞特性
3)  hysteretic characteristic
迟滞特性
1.
The dry friction damping hysteretic characteristic of steel friction draft gears is simulated by the equation which describes the suspension forces in the suspension system.
通过描述悬挂系统中悬挂力的数学方程模拟了钢摩擦缓冲器实际的干摩擦阻尼迟滞特性,通过大量缓冲器的冲击试验结果拟合出缓冲器的动态特性曲线的上边线,从而建立了钢摩擦缓冲器数值模型。
4)  hysteresis characteristic
滞迟特性
1.
Through the experimental research and FEA(Finite Element Analysis) simulation on bending of pre-pressed multi-layer assembled flexible link,it is indicated that this kind of flexible link has favorable hysteresis characteristic,which varies with the pre-pressing force,and can effectively restrain the vibration of the flexib.
为抑制柔性机械臂的振颤,该文提出利用组合构件的滞迟特性来改善机械臂的动力学品质以达到减振的作用;介绍了预压叠层柔性机械臂力—变形本构关系的试验研究及有限元数值仿真。
5)  non-linear hysteretic characteristic
非线性迟滞特性
1.
The test results show that the resilience of dissipater is influenced by frequency and amplitude and has obvious non-linear hysteretic characteristic.
采用电液伺服材料试验机的位移加载方式,对金属橡胶/橡胶复合叠层耗能器进行动态试验研究,结果表明:耗能器的恢复力同时受频率和振幅的影响具有非线性迟滞特性
6)  dynamic hysteresis behavior
动态迟滞特性
补充资料:迟滞


迟滞


  物理学术语。以视频方式显示的影像学装置中,视频摄像机的特性参数之一,也称时间响应。迟滞是视频摄像机对输入给它的亮度快速变化响应速度的测量参数。比如当以1/30s的间隔读出一个视频帧时,摄像机需一系列帧幅来达到平衡值。此现象称“建成迟滞”(buildup lag)。在另一种情况下,当亮度在摄像机“消隐”时到达摄像机,则无信号电流读出,但在靶上有电荷建成。亮度脉冲中止后摄像机增辉,开始正常的视频读出,因靶上有遗留的残余电荷,在第二、三帧时仍有可感知的信号水平。称“余辉迟滞”(decay lag)。摄像机若迟滞明显,则可限制成像系统的时间分辨力。
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条