说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 氮气分压
1)  nitrogen partial pressure
氮气分压
1.
The crystal structure and mechanical properties of (Ti,Al)N films are strongly dependent on the nitrogen partial pressure The st.
试验结果表明,采用Ti,Al原子比为1∶1的靶材在不同的氮气分压下制成的样品薄膜在硬度方面有差异,在氮气分压为1。
2.
It was found that the nitrogen partial pressure and substrate temperature are thetwo important factors affecting the formation of Fe-N phases and their magneticproperties.
系统研究了氮气分压、基底温度,溅射功率等制备工艺条件对 Fe-N 薄膜结构和磁性的影响,以及 Fe-N 薄膜的饱和磁化强度的尺寸效应。
2)  synthesis conversion
最低氮气分压
3)  N2-pressurized
氮气加压
4)  compressed Nitrogen
压缩氮气
5)  nitrogen pressure
氮气压力
1.
Polyphase Y-α/β-Sialon powders were prepared by SHS method, with St, Al, Y2O3 and Si3N4as raw materials under high nitrogen pressure.
本文通过组成设计,以Si、Al、Y2O3为原料,Si3N4为稀释剂,利用自蔓延高温合成法(SHS)制备了Y-α/β-Sialon粉末;并利用XRD、化学分析法分别研究了α-Sialon简称α′)、β-Sialon简称β′)相组成和游离硅含量;且详细讨论了氮气压力、稀释剂含量对生成物Y-α/β-Sialon中的α′、β′相及残余硅含量的影响。
2.
The effect of Y-TZP (3mol% Y2O3) and nitrogen pressure on the sintering properties,phase composition, microstructure and mechanical properties of GPS Si3N4 Ceramic Materials with Y2O3 and Al2O3 as sintering aids were studied.
本文研究了Y-TZP(3mol%Y2O3)和氮气压力对GPSSi3N4陶瓷材料的烧结性能和力学性能、相组成及微观结构的影响,添加5wt%、10wt%、15wt%、20wt%Y-TZP的氨化硅复合材料在1770~1800℃,氮气压力分别为1MPa、2MPa、3MPa下烧成,获得相对密度>95%的烧结体。
6)  low nitrogen pressure
低氮气压
1.
Self-propagating High-temperature Synthesis(SHS)of Si 3N 4/SiC composite powder from silicon and carbon powder under low nitrogen pressure has been investigated,it is feasible to synthesize the composite powder in-situ under nitrogen pressure 0 5~0 6?MPa.
探讨了硅粉与碳粉混合料在 0 5~ 0 6MPa的低氮气压下自蔓延高温合成 (SHS)的可行性 ,起始原料中加入适量的Si3N4作稀释剂 ,可促进Si粉向Si3N4转变。
补充资料:电容分压器(见分压器)


电容分压器(见分压器)
capacitor voltage dividers

d)onf。日g无en丫oq{电容分压器(eaPaeitor voltage dividers)见分压器。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条