1) Connection mode
接线方式
1.
Selection of connection mode of 10 kV distribution network in central urban area;
面向中心城区的10kV配电网接线方式选型
2.
Analysis of typical connection modes of urban middle voltage distribution network;
城市中压配电网典型接线方式分析
2) wiring mode
接线方式
1.
Parameter selection,protection and wiring mode of the series reactor were analyzed.
为了消除系统谐波、谐振及限制合闸涌流,高压并联电容器装置中大多串联有电抗器,对串联电抗器的参数选取、保护问题、接线方式问题进行了分析,提出了合理的参数选型、保护配置及正确的接线方式,以确保电抗器乃至整个电容器组安全运行。
2.
The problems in the aspects of design type selecting and wiring mode for HV electric energy measuring device were pointed out.
指出了当前高压电能计量装置在设计选型和接线方式方面存在的问题,针对在线运行高压电能计量装置设计选型和接线方式对其计量结果准确性和可靠性的影响进行了分析探讨,提出了改进建议,并对改进前后2种不同的高压电能计量装置设计选型和接线方式的实际电量进行了比对考核。
3.
The principle and method for judging 48 wiring modes of the three-phase and three-wire Watt-hour meter by using pincers power factor meter are discussed in this paper.
讨论了用钳形功率因数表在线判断三相三线有功电能表48种接线方式的原理及方法。
3) mode of connection
接线方式
1.
Practice and ponder on changing mode of connection of rectiformer;
整流变压器改变接线方式的实践与思考
2.
The principles for the mode of connection of whole compensating device and how to choosing the parameter of capacitor and current-limiting reactor are analyzed.
就电容器、串联电抗器的参数选取及整个补偿装置的接线方式进行了原理分析,提出了合理的参数选型方法及正确的接线方式,以确保整个补偿系统的安全可靠运行。
3.
It gives technical characteristics about the construction of capacitive winding, mode of connection and circuit protection in 3phase capacitance lowloss energysaving power transformer.
提供了其中的容性绕组的结构、接线方式以及电路保护等技术特征。
4) wiring method
接线方式
1.
Several DCS-based wiring methods for connection of auxiliary units in medium and small sized power stations into the DCS control system are introduced.
介绍了基于DCS下,中小型电厂辅机接入DCS控制的几种接线方式,分析了各种接入方式的优缺点,提出了今后控制方式的发展方向。
2.
The wiring errors methods of voltage loop will eliminate by multimeter and phase angle table;the wiring methods of electric current loop will judge though moment way or phase volt-ampere way.
电能计量装置错误接线方式有几百种,在实际检查和分析错误接线时,一般都采用"逐步逼近法",即先通过对电压、电流回路的检查,使电压、电流回路发生错误接线的几率大大降低。
5) wiring schemes of current transformer
TA接线方式
1.
The existing problems in wiring schemes of current transformer(TA) used in microcomputer-based differential protection for main transformer in 110kV substation with internal bridge connection operated by Chengdu Power Supply Bureau are analyzed.
对目前成都电业局110 kV内桥接线变电站中主变差动微机保护TA接线方式存在的问题进行了分析,建议进行差动保护电流接线方式设计时,将主变每一侧开关的TA电流分别引至主变保护屏,分别接至对应的屏内小TA,不能在端子上组合成和电流以后再接入屏内小TA,否则发生主变差动保护区外故障,在TA饱和的情况下,差动保护有误动的可能。
6) Δ-connectes
Δ接线方式
补充资料：油气田开发方式(见油气田生产方式)
油气田开发方式(见油气田生产方式)
development pattern of oil and gas field:see recovery pattern of oil and gas field
a垃d gas月e卫d) 、‘。尸卫Jlent见油气田小冰、*pa士teroof ojl
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条