1) size composition of sinter product
成品矿粒度
2) product size characteristic
产品粒度组成特性
1.
In this paper,it's discussed that the ball size has a optimization to different monosized ore by the mill of different ball size,which has a best product size characteristic.
在此基础上 ,研究了在不同装球制度下磨机产品粒度组成特性 ,得出只有采用与物料各级别相对应的适宜钢球配比组成的装球制度来磨碎 ,其产品粒度组成特性最好 ,为选矿厂根据入磨物料粒度组成而采用相适应的装球制度提供了理论依
3) finished product minerals
成品矿
1.
Meanwhile,it plays an important role in surmountting geological grade drop and stabilization finished product minerals grade.
对我国各类矿山的露采区闭坑后 ,克服地质品位下降 ,稳定成品矿品位有十分重要的意
4) feeding mine granularity
给矿粒度
1.
074mm feeding mine granularity was increased 5%-10%,gravity concentrate extract mine grade Was increasd 0.
介绍了一、二次球磨作业10:3工艺在某选矿厂一选车间的应用,结果表明:使用该工艺后,重选作业-200目给矿粒度质量分数提高5%-10%,重精品住提高0。
5) ore-crushing size
碎矿粒度
1.
After reformation,ore-crushing size reduces obviously,and Remarkable economic results have been achieved.
改造后,碎矿粒度明显降低,取得了显著的经济效益。
6) grinding size
磨矿粒度
1.
Molar ratio of acid to zinc mole, retention time,additive,grinding size and oxygen pressure were studied to determine their influence on the extractions of Zn,Fe,Ga,Ge.
重点考察了酸锌摩尔比、时间、添加剂、磨矿粒度、氧分压等因素对锌、铁、镓、锗浸出率的影响,在适宜工艺条件下,锌、铁、镓、锗的浸出率可分别达到98%、85%、85%、88%。
补充资料：成品检验(见成品验证)
成品检验(见成品验证)
finished product inspection: see finished product verification
山e叩Pinjian四n成品检脸(finishedp耐uct inspection)见成品脸证。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条