1) tensile strength of tablets
片剂抗张强度
1.
The effects of formulation and technological factors of high speed wet granulation technology on tensile strength of tablets,and the relationship of powder characteristics of granules and tensile strength of tablets were investigated.
考察了高速搅拌湿法制粒工艺中制粒及压片两步的处方、工艺因素与颗粒成片后片剂抗张强度的关系以及颗粒性质与片剂抗张强度的关系。
2) tensile strength
抗张强度
1.
The results showed that rock tensile strength of sample with a diameter of 25 mm and a length of 25mm treated by drilling fluid was higher than that of untreated rock samples with a diameter of 50mm and a length of 50mm.
在考虑试验岩样尺度效应的基础上,进行的模拟地层条件下钻井液对岩石力学性质影响的试验研究结果表明:经钻井液处理后的25mm×25mm岩样的抗张强度高于未经钻井液处理的50mm×50mm岩样,且处理后的岩样抗张强度均高于未处理的岩样。
2.
The improvements of packaging paper strengths,including stiffness,ring crush compression resistance,folding endurance and tensile strength,by novel strengthening agents was investigated.
该文探讨了用新型增强剂提高纸页的包装强度:挺度、环压强度、耐折度、抗张强度;比较了几种增强剂对提高纸页包装强度的效果,确定了最合适的增强剂及用量,并研究了最合适的增强剂对不同纸浆、不同定量纸页包装强度的影响,确定采用4号增强剂且用量为0。
3.
The results showed that the brightness of the hand-sheets decreased with increasing dosage of SDS;and the tensile strength of hand-sheets increased first with increasing charge of SDS,then decreased;however,the tearing strength of the hand-sheets decreased first with the increasing dosage of SDS and then increased;the air permeability of the hand-sheets reached maximum at a certain dosa.
研究表明,纸页的白度随非离子瓜尔胶浓度的增加而降低;抗张强度先随非离子瓜尔胶添加量的增大而增大其后随之下降;撕裂度先随非离子瓜尔胶用量的升高而下降其后随之提高;透气度先随非离子瓜尔胶用量的升高而增加达到一个峰值后又降低。
3) tensile strength after immersion in water
湿抗张强度
4) wet zero tensile
湿零距抗张强度
5) room tensile strength
室温抗张强度
1.
The room tensile strength of the filament exhibitsa normal distribution.
测定了 SiC(W 芯)纤维的抗张强度,实验表明:对用 CVD 法制备的 SiC(W 芯)纤维的抗张强度测试值随试样标距的增大而降低,其室温抗张强度呈正态分布状态。
6) Diametral tensile strength
径向抗张强度
1.
Objective To study the effects of colour on diametral tensile strength and bonding strength of resin.
目的:研究颜色的不同对树脂粘结剂径向抗张强度及其与瓷粘结强度的影响。
2.
METHODS: Five cylindrical compressive strength specimens at an 8-mm height and 4-mm diameter were prepared, as well as 5 cylindrical diametral tensile strength specimens at a 3-mm height and 6-mm diameter.
方法:分别制作高8mm,直径4mm的不同树脂粘结剂的圆柱形压缩强度试件5个,高3mm,直径6mm的圆柱形径向抗张强度试件5个,在AGS-500万能材料试验机测其压缩强度和径向抗张强度。
补充资料：抗张强度测定仪
分子式：
CAS号：
性质：又称抗张强度测定仪。是测定纸和纸板所能承受最大张力的仪器。该仪器目前有摆锤式、扭力式和电感应式等类型，以摆锤式最为常用。对抗张强度的测定是判断纸和纸板内纤维的结合强度和交织状况，是纸和纸板最基本的强度之一。
CAS号：
性质：又称抗张强度测定仪。是测定纸和纸板所能承受最大张力的仪器。该仪器目前有摆锤式、扭力式和电感应式等类型，以摆锤式最为常用。对抗张强度的测定是判断纸和纸板内纤维的结合强度和交织状况，是纸和纸板最基本的强度之一。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条